How To Determine If Brophy Drawbar BM96 Will Clear Bumper In Rise Position
Question:
What is the distance from the pin to the vertical segment? I’m trying to measure for bumper clearance. Thanks
asked by: Keenan M
0
Expert Reply:
If using the Brophy Drawbar part # BM96 in the rise position you'd need to have no more than 3" from the center of the hitch pin hole to the edge of the bumper. That is the distance from the center of the hitch pin hole to the start of the gusset. The distance from the center of the hitch pin hole to the back of the upright (excluding gusset) is 4-1/2".
expert reply by:
Conner L
0
Product Page this Question was Asked From
Brophy Drawbar for 1-1/4" Hitches - 5-1/2" Rise, 6" Drop - 7-1/4" Long - 3.5K
- Trailer Hitch Ball Mount
- Fixed Ball Mount
- No Ball
- 3/4 Inch Ball Hole Diameter
- Steel Shank - Gloss Black
- Drop - 6 Inch
- Rise - 5 Inch
- Fits 1-1/4 Inch Hitch
- 3500 lbs GTW
- Class II
- Brophy
more information >
Continue Researching
- Article: How to Measure for Trailer Hitch Drop
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Tire Sizing
- Article: Flat Towing Package for 2018 Jeep Wrangler JL and JL Unlimited
- Q&A: How to Carry Bikes With 2018 Honda Civic Hatchback With Center Exhaust
- Article: Brake Controller Installation: Starting from Scratch
- Q&A: Correct Trailer Hitch Fit for a 2006 Scion xB
- Q&A: Hitch and Wiring Recommendation for a 2006 xB
- Q&A: Why Aren't Adjustable Ball Mounts Made for 1-1/4 inch Trailer Hitch
- Q&A: What Type of Grease for Lubricating Trailer Jack
- Q&A: What Length of Hitch Pin Lock for Holding Attachment into Gen-Y Adjustable Ball Mount
- Q&A: Does Installing A Wiring Harness On A 2021 Jeep Wrangler JL Require A Wire Run To The Battery?
- Article: Routing the Power Wire for a Trailer Wiring Harness
- Article: How to Choose the Right Trailer Hitch Class