Is Certain Width Needed to Mount Solera XL Power Awning Support Arms
Question:
width needed to mount the arms?
asked by: Everett M
Helpful Expert Reply:
There isn't a specific width needed to mount the Solera XL Power Awning Support Arms for RVs # LC362241.
The measurements you need to ensure you have for the arms is 78" straight down from the awning rail and 4-1/2" between the awning rail and top of your entry door.
The width you need is for the roller assembly, such as the 12' wide Solera XL Power Awning Roller Assembly # LCV000334919.
I have added a link to our entire selection of power roller assemblies, which range from 11' to 21' wide.
Products Referenced in This Question
Replacement Roller and Fabric Kit for 12' Solera XL Power RV Awnings - White Fade
- RV Awnings
- Roller and Fabric Kits
- Powered - 12V
- Extends 116 Inches
- 12 Feet Wide
- White Fade
- Lippert
more information >
Product Page this Question was Asked From
Replacement Support Arms for Solera 12V XL Power RV Awnings - 78" Long - White
- Accessories and Parts
- RV Awnings
- Arms
- 78 Inch Long
- Standard Head
- Support Arms
- Solera Replacement
- White
- Lippert
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Recommended Replacement For A Magic Chef MCD990ARB RV Microwave
- Q&A: What Size Wrench Would Be Needed to Install Oil Cap part # RG04-30
- Q&A: My Axle Has No Cotter Pin Hole Can I Install Bearing Kit for #84 Spindle?
- Q&A: Is Solera Awning Head Opposite of Power Head on Awning Setup
- Q&A: Correct Replacement Support Arm Assembly For 2021 Jayco North Point 977RLBH W/ Solera Power Awning
- Q&A: Correct Replacement Arm for Solera V000436372 Awning
- Q&A: Replacement 9/16 Inch Wheel Stud for 5/8 Inch Wheel Stud Hubs
- Article: How to Repair an RV Roof