Is Drilling Required to Install the Husky Liners Custom Molded Mud Flaps on a 2012 Toyota Tundra SR5
Question:
Hello, I have a 2012 Tundra SR5 and it has factory installed front and rear mud flaps, but I have oversized tires. I wish to order a pair of these front flaps, Part# HL56911. If I remove the factory pair, will the holes in this model fit the pre-drilled holes from where the Toyota factory flap fit? I just dont want to have to drill more holes for your product to fit my truck. Please advise, and thank you.
asked by: Perry Y
Expert Reply:
I spoke with my contact at Husky Liners and the Custom Molded Mud Flaps Front, # HL56911, and Rear, # HL57911, do not require drilling for installation. These mud flaps will use the existing holes from your factory mud flaps for an easy installation.
These mud flaps also come with a paint protection film that protect the mud guard mounting surface on your fenders against wear. The only tools required for installation are a short Phillips screwdriver and a 10mm wrench.
Product Page this Question was Asked From
Husky Liners Custom Molded Mud Flaps - Front Pair
- Mud Flaps
- Custom Fit
- Front Pair
- Wheel Well Mount
- Custom Width
- Plastic
- Husky Liners
more information >
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: How Can I Be Sure My Curt Triflex Brake Controller Is Working Worrectly
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Article: Trailer Tire Sizing
- Q&A: What Roof Rack Kits Will Work with the RetraxPRO XR Hard Tonneau Covers
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Lug Nut Torque Chart for Trailer Wheels
- Q&A: Troubleshooting Curt Triflex Brake Controller that Stopped Working with Brakes
- Article: How to Measure for Trailer Hitch Drop
- Article: My Trailer Hitch Doesn't Fit
- Q&A: Recommended Crossbar Length for Rhino-Rack Vortex Rack for Retrax Pro XR series Tonneau Cover