Right Side Trailer Brake and Turn Signal are Not Working but All Other Lights Work
Question:
MY TRAILER LIGHT ON THE RIGHT SIDE. THE STOP AND TURN SIGNAL QUITE WORKING. THE RUNNING LIGHT WORKS. THE LEFT STDE EVERYTHING WORKS.
asked by: LARRY
Expert Reply:
This is a classic ground problem, especially since everything else is working. It could be at the trailer connector, vehicle or trailer side, or at the light itself. Start with the vehicle side connector and make sure it is properly grounded and that any corrosion or dirt is cleaned out of the connector. Then do the same with the trailer side connector and the main ground for the trailer.
Some lights ground through a wire and others ground through the mounting studs. In both cases the grounds need to be attached to a clean and corrosion free bare metal surface.
Product Page this Question was Asked From
Combination LED Trailer Tail Light - Submersible - 6 Function - 11 Diodes - Passenger Side
- Trailer Lights
- Tail Lights
- Rear Reflector
- Side Marker
- Side Reflector
- Stop/Turn/Tail
- Square
- Surface Mount
- Submersible Lights
- LED Light
- 5L x 5W Inch
- Red
- Optronics
more information >
Continue Researching
- Article: Trailer Wiring Diagrams
- Article: Our Team Picked The Best Camping Gear of the Year - Here Are Their Top Choices
- Article: Trailer Lighting Requirements
- Q&A: Hub And Drum Replacement for 90865 Rockwell Hub and Drum
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Q&A: Solution to Replace 8k Kodiak XL NevR Lube Hub Drums
- Q&A: Is There A Way To Determine The Key Code For A Bauer Products Entry Door Lock
- Q&A: Recommended Flat Towing Components For A 2024 Chevy Trax
- Q&A: Replacement For TDE-LP750 Trailer Actuator
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Troubleshooting 4 and 5-Way Wiring Installations
- Q&A: Correct Replacement for TDE 46210 Trailer Hub
- Q&A: Similar Tire Size Replacement for 7.50x16 That Is Radial Construction
- Article: Trailer Maintenance Schedule