Air Lift Suspension Enhancement Kit that Fits 2020Thor Fourwinds 31E

Question

Question:

Will this product fit my RV?

asked by: Edgar G

0

Expert Reply:

Yes the Air Lift LoadLifter 5000 # AL57242 is a confirmed fit for your 2020 Thor Fourwinds 31E motorhome!

For a compressor kit then the heavy duty part # AL25854 will work great to make inflating the bags and maintaining them easier. The compressor will inflate faster than standard compressors and the gauge inside the vehicle will allow you to monitor and inflate them from inside the vehicle.

expert reply by: Jameson C

0

Answer 1

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 2

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

We've got a couple options for Air Lift kits that will a 2002 Ford E-450 chassis. Which one you need will depend on where the supply lines are ran on the frame. Both kits have a 5,000 lbs load leveling capacity. I have listed them below: Outside…

view full answer...

Answer 5

The plunger pins are usually specific to the brand of jack and usually are not interchangeable. Unfortunately, without knowing the manufacturer and model number of your existing jack, I cannot say with certainty that the pin will work for you. I have…

view full answer...

Answer 6

So long as your customer's Pull-Rite 24k 5th wheel hitch mounts to industry standard rails, you'll want the B&W Custom Installation Kit w/ Base Rails item #BWRVK2402. These custom fit brackets mount to existing holes in your F-350's…

view full answer...

Answer 7

The Ford Q-206 document is one that we hare very familiar with since it shows the nearly inaccessible location of the brake controller port! For the 2006 Ford F-53 chassis you should be able to use harness #3035-P to plug in a P3 brake controller…

view full answer...

Answer 8

I check with Phoenix Faucets and they said the thread diameter of the #PF182011 is 1-1/4 inch.

view full answer...

Answer 9

For your Thor Freedom Elite 30FE, the chassis is the Ford E-450 and the weight is around 14,500 lbs at max capacity. For your motorhome I recommend the SumoSprings Maxim Custom Helper Springs - Rear Axle #SSR-106-47-1. The stronger spring will help…

view full answer...

Answer 10

We do have an option to upgrade the support for the rear suspension on your 2021 Ford E-450 cutaway chassis, and the best option that will fit are SumoSprings: - SumoSprings Maxim Custom Helper Springs #SSR-106-47-1 The #SSR-106-47-1 have a 5,000 lb…

view full answer...

Air Lift Suspension Enhancement Kit that Fits 2020Thor Fourwinds 31E

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching