How To Wire the Pollak Metal 7-Pole, RV-Style Trailer Socket
Question:
will hooking this up to the left/stop wire of the vehicle also activate the device eg light if I turn on my left turn signal?
asked by: An P
0
Expert Reply:
In regards to installing the Pollak Metal 7-Pole, RV-Style Trailer Socket part # PK12703, the colors mentioned are just a reference and you should use the actual pin locations for proper installation. I have attached a link below with these correct locations. The yellow wire is mostly used for the left stop/turn signal circuit so in which case it would need to be installed on the pin in the 9 o'clock position (facing forward).
expert reply by:
Conner L
0
Product Page this Question was Asked From
Pollak Metal 7-Pole, RV-Style Trailer Socket - Vehicle End
- Trailer Wiring
- Trailer Connectors
- Vehicle End Connector
- Plug Only
- 7 Round - Blade
- Pollak
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: Do 8k Oil Bath End Caps On Lippert Axle Interchange With Dexter End Caps
- Q&A: Recommended Electric Over Hydraulic Brake Set Up for 2016 Montana 3710FL 5th Wheel
- Q&A: Replacement Grease Seals For TRP GS-1719DL
- Q&A: Is Adapter Needed to Install Dometic Water Heater # DMC74FR In Place of Atwood
- Article: Brake Controller Installation: Starting from Scratch
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Article: Printable Trailer Bolt Hole Pattern Template
- Q&A: Recommendation for Installation of a Brake Mounting Flange on a Trailer Spindle and Axle
- Q&A: Do I Need Brakes On Both Axles of a Car Hauler Trailer?
- Q&A: Leaf Spring Recommendation for 4,400 lb Trailer Axle
- Article: How to Replace Trailer Leaf Springs in 5 Steps
- Article: Hitch Adapters and Extenders
- Article: Troubleshooting Brake Controller Installations