What Is the Compressed Length of the 10 Taylor Made Marine Gas Strut for Boat Hatches

Question

Question:

what is the stroke length or the compressed length? thanks

asked by: Chris P

1

Helpful Expert Reply:

The Taylor Made Marine Gas Strut for Boat Hatches part # 3691822-10 has a compressed length of 7".

expert reply by: Conner L

1

Answer 1

Draw Tite does offer a front hitch that fits your 2004 Dodge Ram 3500 but it's the part #65046 and not the part #65033 you mentioned that fits the lighter duty trucks.

view full answer...

Answer 2

The correct part to replace your current converter charger is the Replacement Converter for Parallax/Magnetek or WFCO RV Power Centers - 55 Amp part #PD4655V. This is an exact replacement and will be all you need to get back operational. I have…

view full answer...

Answer 3

The mounting for a front trailer hitch on a 2005 Dodge Ram 2500 is different than on a 1500 which is why drilling is required on a 2500. If you take a look at the cut out of the instructions of Draw-Tite Front Mount Hitch #65033, which fits a 2005…

view full answer...

Answer 4

The strut you're asking about, part #3691826-50 is rated at 50 lbs, which is the amount of force required to compress it. Therefore, you'd want to hatch lid to weigh significantly less than that. Taylor Made tells me that because this…

view full answer...

Answer 5

I went out the warehouse and the Taylor Made Marine Gas Strut for Boat Hatches - 10 mm Socket - 20 lb Force part #3691822 is 7-1/2" compressed center of ball socket to center of ball socket. You will also need brackets part #3691881 and…

view full answer...

Answer 6

I may have a solution for you, but the Replacement Lid Support for Yakima Cargo Boxes #8880683 will not work to replace the gas strut on your old Yakima Rocketbox. However, even though they don't carry them as a replacement part any longer,…

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 8

The Progressive Dynamics Replacement Section #PD4655V does have a jumper to change the charging profile to lithium compatible. You'll simply need to move the black jumper over from the WIZ side to the LI side.

view full answer...

Answer 9

I attached a picture of how the Draw Tite front hitch part #65063 installs and it uses the tow hooks to bolt through the mounting plate of the hitch to the truck frame. Since you have the area available where the tow hooks install I'd…

view full answer...

Answer 10

Since the part #PD4655V has come out and has ability to switch between lithium and lead acid batteries the part PD4655LIV was discontinued. At one point there were separate parts for lithium and lead acid batteries but since the current one can do…

view full answer...

Answer 11

The Class V hitch we have for your 2004 Dodge Ram 2500 with the best ground clearance is the Curt hitch part #C15809. It doesn't tuck right under the rear bumper like what you can see in the attached picture but it does sit the highest.

view full answer...

Answer 12

To convert the WFCO WF-8955PEC to be lithium compatible you'd need the part #PD4655V and you'd be set. This fits in the panel without any modifications.

view full answer...

What Is the Compressed Length of the 10 Taylor Made Marine Gas Strut for Boat Hatches

Product Page this Question was Asked From

Continue Researching