How To Choose Correct Replacement Hubs for 2005 Wesco Boat Trailer
Question:
I have a 2005 Wesco boat trailer with a 2005 16 ft carolina skiff 1655 . I need to replace the hubs on a single axle trailer. The GAWR is 1560 lbs. What do you recommend?
asked by: Lawrence P
Expert Reply:
In order to choose the correct replacement hubs for a trailer you'll need to know the axle capacity. The make and model of the trailer is usually irreverent as we don't have any way to look up part numbers from this. The axle capacity can be found on the axle tube itself. The smaller trailers with an axle capacity of 2,000 lbs use the Trailer Idler Hub Assembly part # AKIHUB-545-2-G-1K which has L44643 bearings.
I have attached a full list of trailer hub options which you will need to filter based on axle capacity if the above is not a match. Please note, you must also pay attention to the bolt pattern as well.
Product Page this Question was Asked From
Trailer Idler Hub Assembly for 2,000-lb Axles - 5 on 4-1/2 - Galvanized
- Trailer Hubs and Drums
- Hub
- Standard
- L44643
- L44643
- For 2000 lbs Axles
- 1/2 Inch Stud
- 5 on 4-1/2 Inch
- 10 Inch Wheel
- 12 Inch Wheel
- etrailer
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Shop: Easy Grease Trailer Idler Hub Assembly for 2K Axles - 5 on 4-1/2 - Galvanized
- Video: etrailer Trailer Idler Hub Assembly Review and Installation
- Video: Review of Powerbuilt Lubricants Sealants Adhesives - Greasing Tools - ALL647646
- Shop: CE Smith Trailer Idler Hub Assembly w/ Case for 3.5K Axles - 5 on 4-1/2 - Galvanized - Pre-Greased
- Shop: Kodiak Ceramic Brake Pads w/Stainless Steel Backing Plate - 3,500 lbs to 6,000 lbs
- Shop: Optronics LED Clearance or Side Marker Light - Submersible - 3 Diodes - Rectangle - Amber Lens
- Search Results: wire loom
- Search Results: optronics
- Search Results: led boat trailer lights
- Shop: 20 Ft 4-Way Trailer Wiring Harness - Wishbone Style - 30" Ground
- Shop: Optronics LED Combination Trailer Tail Lights - Submersible - 40 Diodes - Driver and Passenger Side
- Shop: Hopkins Endurance Easy-Pull Harness with 4-Pole Flat Trailer Connector - Trailer End - 25' Long
- Search Results: wire connectors
- Search Results: packing trailer bearing
- Search Results: waterproof wire connector
- Search Results: marine bearing grease
- Q&A: Can I Turn or Grind Disc Brake Hub/Rotor to Remove Rust
- Shop: Trailer Wiring
- Video: Kodiak Brake Pads Review and Installation
- Video: Kodiak Trailer Brakes K225CPSS Review
- Video: etrailer Trailer Idler Hub Assembly Installation
- Q&A: Trailer Wheel Seems Stiff, Not as Easy to Turn After Repacking Bearings with Grease
- Q&A: Recommending a Hub Assembly for a 4 x 8 Trailer
- Q&A: Can Trailer Hub AKIHUB-545-2-G-1K Replace Hub that Used Wheel Bolts
- Video: Review of Hydrastar Trailer Brakes - Disc Brakes for Triple Axles - HSE7K-TR1
- Q&A: Replacement Hub Assembly for T.D.E. 11033
- Q&A: Replacement Hub for Tie Down Engineering 11033
- Q&A: Do Hub Races Have to Be Replaced Each Time Bearings Are Changed
- Shop: Roof Rack
- Shop: Trailer Hitch