Can MaxxFan Roof Vent Install in Camper Shell with Carpeted Headliner

Question

Question:

can this be installed on a carpeted truck shell

asked by: Stephen T

0

Expert Reply:

Yes you could install the MaxxFan Plus Roof Vent w/ 12V Fan # MA00-04500K in your truck camper shell that has a carpeted headliner.

expert reply by: Jameson C

0

Answer 1

The MaxxAir MaxxFan Plus - Smoke #MA00-04500K will work on your fiberglass truck cap, but highway speeds will not allow it to stay open. The remote will work fine from inside you truck cab. If you want to be able to drive the highway speeds, I…

view full answer...

Answer 2

There are not specific instructions on how to replace the Replacement Rain Shield for MaxxFan Deluxe Roof Vent - Smoke part #MA05-30520 on the MaxxFan Deluxe Roof Vent w/ 12V Fan - Manual Lift - 4 Speed - Smoke part #MA00-06401K. However,…

view full answer...

Answer 3

All of the trailer roof vents are basically designed to fit the same hole dimensions in the roof of the trailer so the garnish part #FVK1060-81 would work well with the MaxxAir Deluxe Fan part #MA00-07000K that you also referenced.

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

Yes, I have listed for your below the roof rack systems from Rhino-Rack, Thule, and Yakima that will fit the RetraxPRO XR Hard Tonneau Covers like part #RTT-80243 for your 2019 Ram 1500. Rhino-Rack Vortex Crossbar System part #RRVA180B-RRRLT600…

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 9

You are correct that this refrigerator does not have an ON/OFF switch or function. The best you can do is "Standby" that draws an unknown amount of power. One option is to pull the 12-Volt fuse at the RV power center. A much better option…

view full answer...

Answer 10

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 11

To find the load capacity for your axle you should look on the trailer VIN plate or sticker that lists the VIN number. The weight rating of the axle should be listed on that same plate or sticker. Also, the axle could have a tag or plate on it that…

view full answer...

Answer 12

Traditionally, trailer manufacturers did not use electric brakes on boat trailers because the brake magnet wiring and trailer wiring did not always have the best insulation or water protection. These days, more and more manufacturers are using…

view full answer...

Can MaxxFan Roof Vent Install in Camper Shell with Carpeted Headliner

Product Page this Question was Asked From

Continue Researching