Installation of Curt Hitch Receiver on 2019 Jeep Compass Without Predrilled Frame Side Holes
Question:
My 2019 Jeep Compass doesnt have the pre-drilled side holes for the carriage bolts? What do I do?
asked by: James M
0
Expert Reply:
For your 2019 Jeep Compass, to install the Curt Hitch # C13363 which is a custom fit, you would need to drill those holes and install the hardware. We haven't seen any models that don't have the two holes on each side of the vehicle in those frame rails, so they would need to be added.
expert reply by:
Jason S
0
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- Custom Fit Hitch
- Class III
- 600 lbs TW
- 4000 lbs GTW
- 2 Inch Hitch
- Concealed Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Replacement for Dexter Mobile Home Axle Grease Seal 10-41
- Q&A: Torque Rating for Spindle Nut on Trailer Hubs
- Q&A: Recommended Hitch for a 2023 Jeep Compass
- Q&A: Dexter Brake Assembly Recommendations to Replace Part Number 023-357-00
- Q&A: Replacement Surge Brake Actuator To Replace Tie Down Model 125 12,500LB Drop Actuator
- Q&A: Dual Propane LP Tank Setup 100 Lb for RV or Travel Trailer
- Q&A: Replacement Brake Assemblies for Dexter 023-358-00 Trailer Brakes
- Article: Trailer Hitch Installation Tips
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: My Trailer Hitch Doesn't Fit
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Flat Towing Package for 2018 Jeep Wrangler JL and JL Unlimited
- Article: Trailer Wiring Diagrams
- Article: Stability Control for Heavy Duty Vehicles