Parts Needed to Convert a Factory 4-Way from a 2006 Nissan Pathfinder to a 7-Way

Question:

mine has a factory adaptor under the dash for a trailer brake control the rear has a factory 4 plug so do they make a 7 plug to fit the factory plug

asked by: Richardwilliams

Expert Reply:

I believe I have a solution that will allow you to install a brake controller on your 2006 Nissan Pathfinder. But you will not be able to use the plug underneath the dash of your vehicle.

You will need a 4 and 7 Way Installation Kit, # ETBC7. Your existing 4-Way will plug into the back of the ETBC7. There will then be 4 wires left to hardwire. Check out the installation instructions I attached for the # ETBC7 as well the installation video.

The brake controller connector under the dash will not be active and fully wired unless the vehicle left the factory with the OEM 7-way, which is why the controller would need to be hardwired like I recommended.

expert reply by: Jameson C