Replacement Top Wind Handle for Atwood Mobile Products Trailer Jack

Question

Question:

I have Atwood Mobile Products boat trailer jack and broke the crank handle. Its made of 1/2inch material cant find a part number. The only number I found was on the gear cover 85701.

asked by: Edward B

1

Helpful Expert Reply:

We do have a top wind crank handle for your Atwood Mobile Products trailer jack. The part that will work for you as a replacement handle is:

- Top Wind Trailer Jack Handle # JP02-010

This will work for a variety of trailer jacks, including your Atwood.

expert reply by: Kyle S

1

Answer 1

Good news, I can help you find a tire for your Sundown Horse Trailer. The 205/90-15 is a close tire size to the 7.00-15. The closest size to a 7.00x15 tire that we offer would be a 225/75-15. One 225/75-15 tire that could work for you is the Kenda…

view full answer...

Answer 2

The psi should be listed on the sidewall of the tire. It is recommended that tires always be inflated to the max psi. The max psi of the tire will depend on the tire's load range, not the weight of the trailer. For instance, we carry 5.30-12…

view full answer...

Answer 3

The Pro Series jack part #PS1400300303 is designed to fit on a 2-1/2 inch diameter pipe and snap ring like you are needing so this would work great.

view full answer...

Answer 4

Your Fuso FE160 has a tow rating and whatever that tow rating happens to be is what the capacity is no matter what the hitch is rated for. So for example if the Fuso is rated for 10,000 pounds gross trailer weight then you would be limited to that…

view full answer...

Answer 5

I spoke with my contact at Dutton-Lainson and he stated that the 203960B number that you pulled from your jack is a label number. That label was used on two different trailer jacks with a 1250 lb weight capacity, sidewind jack #6814 and topwind jack…

view full answer...

Answer 6

The wires of the connector on the part #WG54006-046 are sealed and there isn't a way to remove them. If you check out the diagram I attached, you can see how the pins of the connector are organized.

view full answer...

Answer 7

The closest grease seal we have available to the dimensions you provided is the Redline #10-40. This seal features the same 1.938 inner diameter but a slightly smaller 2.510 outer diameter. This may work as a replacement on your hubs but we do not…

view full answer...

Answer 8

The Dexter Trailer Hub Assembly you referenced, part #AKIHUB-440-2-1K is known as an idler hub. An idler is a hub that is no provisions for trailer brakes. It has no brake drum. Part #8-276-5 is an example of a hub/ drum that has a brake drum that…

view full answer...

Answer 9

My suspicion is that you have a poor ground connection somewhere on your trailer. The fact that everything works fine until the running lights are turned on is the dead giveaway. When the tail lights are turned on, the trailer lighting is drawing…

view full answer...

Answer 10

A slight voltage drop between the controller and the magnets is normal. But you will need around 12 volts at the magnets for proper operation. The only way to know the wire gauge is to strip away the insulation and measure just he copper strands. If…

view full answer...

Replacement Top Wind Handle for Atwood Mobile Products Trailer Jack

Product Page this Question was Asked From

Continue Researching