What Size Hitch Pins Does the Brophy Trailer Hitch Receiver Adapter HTAD Use

Question:

Re hitch adapter HTAD. What size are the holes drilled in the adapter? I’m seeing two size pans half inch and five eights. The half inches typically for a one and quarter inch hitch and five eights for 2 inch hitch. So, the hole that would be where the car is is that a half inch and the hole at the end where you would put in a bike rack for example is that five eights?

asked by: Joe

Expert Reply:

The Brophy Trailer Hitch Receiver Adapter part # HTAD uses two different size hitch pins, part # PC2 which is 1/2" and part # PC3 which is 5/8". The 1/2" pin is used on the part that goes into the trailer hitch and the 5/8" pin is used on the part that the accessory gets installed in.

expert reply by: Conner L