Distance Between Mounting Holes of Optronics Trailer Light # STL90RB
Question:
Im interested in item Item # STL90RB LED light. My only concern is the distance between mounting holes. If they dont match the 7 inch lights installed on my trailer, what would be the return policy?
asked by: William
0
Expert Reply:
The distance between the mounting holes of the Optronics trailer light # STL90RB is 6-1/4 inches so you could easily compare that to what you have now and know if this will fit and work.
I also attached a link to our return policy page as well.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Optronics LED Transit Tail Light - Stop, Tail, Turn - Submersible - 31 Diodes - Red Lens
- Trailer Lights
- Tail Lights
- Stop/Turn/Tail
- Round
- Surface Mount
- Submersible Lights
- LED Light
- 7 Inch Diameter
- Red
- Optronics
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Replacement Motor for Klauber Slide Out Motor K01431B300
- Q&A: Can I Use the Die-Cast Grate for Furrion Range on a Dometic CU-423 Range
- Article: Printable Trailer Bolt Hole Pattern Template
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Q&A: Circuit Board Replacement for MaxxFan 4751KS
- Q&A: Replacement Operator Mechanism for MaxxAir MaxxFan 4751KS
- Q&A: Installing a Brake Controller on a 2007 Chevy Express Van with Factory 7-Way Trailer Connector
- Q&A: Selecting Replacement Trailer Wheel for 1957 Airstream Trailer
- Article: Trailer Wiring Diagrams
- Q&A: How Does Buyers Products Pin with Lanyard # 3373006875 Fasten to Trailer?
- Article: How Much Solar Power Do I Need For My RV?
- Article: How to Rent an RV
- Article: 4 Reasons Not to Use RV Solar Power (And 4 Reasons You Should)
- Article: 5 Things to Know About Weight Distribution Hitches