Recommended Replacement 5" x 5" Trailer Locking Paddle Latch
Question:
Looking for a latch to replace this one. Do you have one that would work?
asked by: Mickey
0
Expert Reply:
From your photos I can see that the face of the latch is 5-1/8" x 5-1/8". The closest option we carry to a paddle handle locking latch this size, is the part # PLR5115. It measures 5-1/2" long x 4-1/4" wide and requires a 4-5/8" long x 3-3/8" cut out. Since I am not sure what size cut out you have this may work for you but you would need to measure the existing cut out to be sure.
expert reply by:
Heather A
0
Product Page this Question was Asked From
Locking Paddle Handle w/ Internal Release - 5-1/2" Long x 4-1/4" Tall - Zinc Plated Steel
- Trailer Door Latch
- Latches
- Flush Latch
- Steel
- Built In Lock
- 3-3/8 x 4-5/8 Inch Cutout
- Polar Hardware
more information >
Continue Researching
- Q&A: Trailer Suspension Hanger Kit for Slipper Springs and 38 inch Wheelbase
- Article: 2 Steps for Finding the Right Weight Distribution Hitch Size
- Article: 5 Things to Know About Weight Distribution Hitches
- Q&A: Charging Auxiliary Battery from Car Cigarette Lighter or 12 Volt Auxiliary Plug Connector
- Q&A: Replacement Hub and Drum for a Dexter 8-133
- Q&A: How to Wire Solera Smart Arm 12V Power RV Awning
- Q&A: 10k Dexter Replacement Hub for a 8-415
- Q&A: Availability of Brake Line Fitting to go from 1/8 inch Male NPT to 3/16 Female FIF
- Q&A: Replacement Landing Gear Jack for Ram Follow 12k Jack on Trailer
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Wiring Diagrams
- Article: How to Adjust Your Trailer Brakes | The Ultimate Guide
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: How to Install a Brake Controller on Chevrolet / GMC 1999-2006 Pickups