Can Curt Multi Fit Hitch Weld to Fleetwood Wildcat Max RKXX travel trailer
Question:
The rear frame rails are tubular 2” wide by 4” deep and extend from the trailer frame to the rear bumper of 9.5”. How will I bolt the hitch on or can it be welded. Rear 4x4 bumper is welded at the end of the 2x4 steel tubular extensions.
asked by: Lynn S
0
Expert Reply:
The Curt RV multi fit hitch part # C13702 that you referenced can be welded to your trailer frame and based on your frame design it would be the best way to attach it.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Adjustable Width Trailer Hitch Receiver for RVs, 18" to 51" Wide
- RV and Camper Hitch
- Frame Mount Hitch
- 18 - 51 Inch Wide Frame
- 500 lbs TW
- 5000 lbs GTW
- 2 Inch Hitch
- Bolt-On
- Weld-On
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Are All RV Hitches for a 2004 Fleetwood Tioga Rated for 3,500 lbs?
- Q&A: Availability Of 33" Ark Stabilizer Jack And Dimensional Diagrams Of Similar Ark Corner Steadies
- Q&A: Recommended Trailer Hitch Receiver For A 1992 Ford E-350 Shuttle Bus
- Article: Trailer Wiring Diagrams
- Q&A: Do Holes Need To Be Drilled Into The Adjustable Arms Of The Stromberg Carlson Adjustable Hitch
- Article: How Level Should a Tow Bar Be When Flat Towing
- Q&A: Trailer Hitch for a 2017 Winnebago Fuse on a 2016 Ford Transit T350 Chassis
- Q&A: Recommended Trailer Hitch for a 2006 Ford E-450 Super Duty
- Q&A: Dimensions of the Curt Adjustable Width Trailer Hitch C13702
- Article: How to Carry Bikes While Towing a Travel Trailer
- Article: My Trailer Hitch Doesn't Fit
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)