How Much To Tighten Center Bolt On Fulton Bolt-Thru Swivel Marine Jack
Question:
The jack wobbles on the swivel part. How much can I tighten the nut in the swivel? Keep tightening until its tight? Thanks.
asked by: Bill L
0
Expert Reply:
I took a look at the installation instructions for the Fulton Bolt-Thru Swivel Marine Jack part # FXP15W and there isn't any sort of torque spec for the center bolt but what is stated is that you will need to tighten the lockout until there is little movement.
Note: The bolt should be installed between the trailer tongue and mount, the jack bracket will be held by the bushing between the locknut and the mount.
expert reply by:
Conner L
0
Product Page this Question was Asked From
Fulton Bolt-Thru Swivel Marine Jack - Weld On - Sidewind - 10" Lift - 1,500 lbs
- Trailer Jack
- Boat Trailer
- Leveling Jacks
- Tongue Jacks
- Steel
- 1001 - 2000 lbs
- Sidewind Jack
- Swivel Jack
- 10 Inch Lift
- Weld-On
- With Wheel
- Fulton
more information >
Continue Researching
- Article: Trailer Wiring Diagrams
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Tester Battery Replacement for Part Number 8010
- Q&A: 2022 Toyota Highlander Wiring for a 7-Way Blade Connector
- Q&A: Troubleshooting Brake Override and Stop/Start Malfunction On 2022 Toyota Highlander Redarc Tow Pro
- Q&A: Electric Over Hydraulic Brake Actuator For A 20000 Lb Trailer With Disc Brakes
- Article: Brake Controller Installation: Starting from Scratch
- Q&A: Parts Needed to Install Brake Controller on 2012 Chrysler Town and Country
- Q&A: Bearing Kit for Trailer that Has 3,500 lb Axles
- Q&A: How to Clear Retract Time Out Return Levelers Error on LCI Level Up System
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Wiring Directions For Bargman LED Recessed Double Tail Light
- Article: Stability Control for Heavy Duty Vehicles