How to Determine if Outboard Motor Lock Will Fit
Question:
I have a lock for my 9.8 Mercury 110. I wanted to get another for my trolling motor, the Minn Kota Endura C2, but the bar lock I already have is to small to go over the tightening handles for the Minn Kota. Will your product be large enough for the handles on the Minn Kota electric trolling motor?
asked by: Ronald Y
Helpful Expert Reply:
The Fulton Outboard Motor Lock # FOML0127 is designed as a universal lock, so I can tell you how to determine if it will fit, but there is no information regarding specific fits on a motor. To determine if it will fit your Minn Kota Endura trolling motor, you will just need to measure how long the handles that secure the motor to your boat are.
I reached out to the manufacturer and they told me the lock was 1-1/2 inches wide on the inside (as well as 12 inches long and just under 1-1/2 inches tall), so if your handles were just under that length you would be able to use the Fulton Outboard Motor Lock # FOML0127.
Product Page this Question was Asked From
Continue Researching
- Q&A: What is the Difference Between Load Range E and F Trailer Tires in the Same Size
- Q&A: Can I Install the Thinline LED Trailer Tail Light Vertically Where It Will Be Submerged?
- Q&A: Hitch Pin Weight Capacity and Sheer Strength
- Q&A: Can FloTool RhinoRamps Max Vehicle Ramp Set Hold the Weight of a 2021 Ram 3500
- Article: Trailer Lighting Requirements
- Q&A: Replacing Older Tie Down Engineering 46210 and 46845 Trailer Hubs
- Q&A: Which is Better for Highway Use 4.80-12 or 5.30-12 Trailer TIres
- Q&A: Will The Fulton Outboard Motor Lock Fit A 2009 Nissan 15 HP Outboard
- Article: Ball Mount Basics: Weight Capacity, Class, and Size
- Article: How to Measure for Trailer Hitch Drop
- Article: Trailer Wiring Diagrams
- Article: What Do I Need To Tow A Trailer?
- Article: Best Boat Trailer Jacks
- Article: Trailer Maintenance Schedule