How to Mount Optronics LED Backup Light # BUL23CB on a Trailer
Question:
How do you mount this light on a trailer?
asked by: Butch D
0
Expert Reply:
The Optronics backup light # BUL23CB, is a flush mount light. You would drill a hole 4-5/16 inches in diameter in the surface you wanted to mount the light to. You would then wire in the pig tail harness, # A49PB, to the trailer wiring. Then mount the light in the grommet, # A45GB, attach the wiring to the light and push it into the hole.
expert reply by:
Michael H
0
Products Referenced in This Question
Rubber Grommet for 4" Round Trailer Lights - PVC
- Accessories and Parts
- Trailer Lights
- Mounting Hardware
- 4 Inch Diameter
- Grommet
- Round
- Optronics
more information >
Right Angle 2-Wire Pigtail for Optronics Backup and Utility Trailer Lights - 2-Prong PL-3 Plug
- Accessories and Parts
- Trailer Lights
- Wiring
- Plugs and Pigtails
- 10 Inch Long
- Two Wire
- Right Angle Pigtail
- Optronics
more information >
Product Page this Question was Asked From
DOT LED Backup Light for Truck or Trailer - Submersible - 27 Diodes - Round - Clear Lens
- Trailer Lights
- Tail Lights
- Backup
- Round
- Recessed Mount
- Non-Submersible Lights
- LED Light
- 4-5/16 Inch Diameter
- White
- Optronics
more information >
Continue Researching
- Article: Brake Controller Installation: Starting from Scratch
- Q&A: Progressive Dynamics Lithium Converter to Work With Power Converter System PD4560K18LS8
- Q&A: Replacement Slide Out Motor For A PowerGear 1010000803 Slide Out Motor
- Q&A: Replacement Red Clearance Lights For Arrow 071 Clearance Lights
- Q&A: Troubleshooting No Power At The Factory Trailer Plug
- Q&A: Lippert Model 1-065-041012-01 Motor Replacement
- Q&A: Replacement Landing Gear Switch for 1A065012-02-01
- Q&A: Replacement Backup Light for Peterson 426E on Motorhome