No Power To 4-Way With Curt T-Connector Vehicle Wiring Harness On a 2003 Jeep Liberty
Question:
I installed this on my 2003 Liberty. Once I finished I checked to see if I was getting power at the 4 way. Didnt have power. I did read that most issues are from a bad ground connection so I reattached the ground screw behind the left tail light. Still no power. Can you help?
asked by: Buster S
Expert Reply:
There are only two possible issues that could cause the Curt T-Connector Vehicle Wiring Harness part # C55382 which is a fit for a 2003 Jeep Liberty not to function correctly. The first is that the pins inside each of the t-connectors are not perfectly seated whether that be from the pins being bent or just not fully engaged so be sure to check that. The next is as you mentioned a bad ground. Please note, you need bare metal contact with the ground wire so be sure you have sanded some of the painted surface away prior to attaching the ground.
Finally, if both of the above do not yield any results then test the wires entering the converter box from the tail lights to see if you have power. If you do have power then that would indicate a bad converter box and I recommend the T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector part # 118524 as a replacement.
I have attached a general troubleshooting help article for you as well that will be helpful to look through.
Products Referenced in This Question
T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Powered Converter
- Custom Fit
- 4 Flat
- Tekonsha
more information >
Product Page this Question was Asked From
Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Converter
- Custom Fit
- 4 Flat
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: How Do You Determine If a 2006 Jeep Liberty Has the Tow Package Wiring?
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Q&A: Where to Plug in Hopkins Vehicle Wiring Harness on 2007 Jeep Liberty
- Q&A: Trailer Wiring Harness on a 2005 Jeep Liberty with Factory Installed Trailer Hitch Receiver
- Q&A: Recommended 4-Way Wiring Harness for 2006 Jeep Liberty
- Article: Trailer Wiring Diagrams
- Q&A: How Long is Replacement Patch Cord # RM-450008
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Where is the Connection Point For Trailer Wiring Harness # 118384 on a 2011 Jeep Liberty
- Article: Tips on How To Tow a Trailer
- Article: Troubleshooting 4 and 5-Way Wiring Installations
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: Determining Trailer Tongue Weight
- Q&A: Wiring 4-Way And 7-Way Connector On 2004 Jeep Liberty To Tow Popup Camper