How Much of a Gap Should There Be In Double Jaw Of Reese Fifth Wheel Hitch
Question:
How close together should I see the jaws when they are closed on trailer?
asked by: Lloyd
0
Expert Reply:
According to Reese there will be about 1/4" of a gap in the jaws that is within tolerance once the trailer is hooked up to the fifth wheel hitch part # RP30047. Since the hitch has a dual jaw design it is impossible to not have a gap once hooked up to the trailer because the jaws need to open enough to hook up the king pin on the trailer. If your hitch has a larger gap than 1/4" in the jaws please let me know and we can troubleshoot further.
expert reply by:
Heather A
0
Product Page this Question was Asked From
Reese 5th Wheel Trailer Hitch - Dual Jaw - 16,000 lbs
- Fifth Wheel Hitch
- Fixed Fifth Wheel
- Aftermarket Below Bed Rails
- 4000 lbs Vertical Load
- 16000 lbs GTW
- Double Pivot
- Standard - Double Jaw
- 13-1/2 - 17 Inch Tall
- Reese
more information >
Featured Help Information
Instructions
Continue Researching
- Article: Sidewinder with Rotating Turret for Short Bed Pickups
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Q&A: Can I Use A Curt A20 With A Reese Sidewinder On A Ram Truck With The Rambox
- Article: Ram Trailer Tow Prep Package
- Q&A: Does Truck with 6-1/2 ft bed Have to Use Slider Hitch for Turning Clearance with Fifth Wheel Hitch
- Article: 5th Wheel Hitch Installation | The Ultimate DIY Guide
- Article: Gooseneck to 5th Wheel Adapters
- Q&A: Proper Replacement for Reliable ACT-7.5K Brake Actuator
- Q&A: What Is An OEM Prep Package And How Do I Know If I Have It
- Q&A: Wedge For Reese Sidewinder RP34FR & Demco Recon 5th Wheel Hitch
- Article: Fifth Wheel Hitch Combinations for Ram Trucks with RamBox (2009-Current)
- Q&A: Recommended Air Bags and Compressor for a 2002 Ford E-450 Class C
- Q&A: Are Capture Plates Needed When Using the Demco Autoslide With a Lippert Road Armor Pin Box