Bolt Hole Pattern on Buyers Products 8 Ton Combination Hitch # 33710050
Question:
What is the mounting hole measurement? Vertical and Horizontal?
asked by: David W
Expert Reply:
The mounting holes on the Buyers Products 8 Ton Combination Hitch # 33710050 are separated by 1-3/4" vertically (center to center) and 3-3/8" horizontally (center to center). This is a pretty standard pattern for pintle hook mounting plates so it's going to be compatible with most hitch mounts, such as the Buyers Products # 337PM90.
I have attached a couple short video reviews on these products below, along with a link that will take you to our complete selection of pintle hook mounts that you can also look through.
Products Referenced in This Question
Buyers Products 2" Pintle Hook Mount - 3 Position - 9" Shank
- Pintle Hitch
- Pintle Mounting Plate
- 17000 lbs GTW
- 2 Inch Hitch Mount
- 8 Holes
- Standard Shank
- Buyers Products
more information >
Product Page this Question was Asked From
Buyers Products 8 Ton Combination Hitch with Mounting Kit - 2" Ball BH8 Series
- Pintle Hitch
- Pintle Hook - Ball Combo
- One Ball
- 16000 lbs GTW
- Bumper Mount
- Plate Mount
- 2 Inch Ball
- No Shank
- Buyers Products
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: How Far Out Will Curt 15400 Extend on 2023 Ram 3500 Cab and Chassis
- Q&A: Dimensions of Mounting Holes on Buyers Products Combination Pintle and Hitch Ball
- Q&A: Mounting Hardware for the Buyers Products 3 Position Pintle Hook Mount Part # 337PM25812
- Q&A: Mounting Flange Dimensions of Curt Hitch # 15800
- Q&A: Comparing the Curt Trailer Hitch Receiver Part # C15800 and C15400
- Q&A: Curt vs. Draw-Tite Trailer Hitch Comparison for a 2016 Subaru Outback Wagon
- Q&A: Recommended Pintle Hitch for 15,000 lb Capacity
- Article: What Do I Need To Tow A Trailer?
- Article: Pintle-Hitches
- Article: Brake Controller Installation: Starting from Scratch