Receiver Needed for 5th Wheel with 4 Inch Bumper with 5-1/2 Inch Drop
Question:
I have a 5th wheel that has a back 4inch balck diamond bumper. The bottom of the bumper rides 5 1/2 inches below the bottom of the I-frame. It looks like this bumper will not clear. Do you have any other bolt ons that will work? Looks like the E100 bumper bolt on will not work either
asked by: Ray W
Expert Reply:
Given the 5-1/2 inch distance between the bottom of the frame members and the bottom of your bumper, the # 13703 will not fit your application.
The E-100 you mention is intended for use with 4 inch square bumpers, as well as the Ultra-Fab # UF35-946402. If you have clearance problems at the rear of the bumper, the Ultra-Fab receiver might be a good alternative as it connects to the underside of the bumper using U-bolts, rather than slipping around it like the E-100 does.
Either receiver has a 3500 lb towing/ 350 lb tongue weight capacity, unless the capacity of the bumper is lower. If this is the case, you will be limited to the bumper capacity.
I have linked you to our selection of RV receivers.
Products Referenced in This Question
Curt RV Bumper 2" Trailer Hitch Receiver
- RV and Camper Hitch
- Bumper Mount Hitch
- 4 x 4 Inch Bumper
- 350 lbs TW
- 3500 lbs GTW
- 2 Inch Hitch
- Bolt-On
- CURT
more information >
Ultra-Fab 2" Motor Home Trailer Hitch Receiver for 4" x 4" Bumpers - 3,500 lbs
- RV and Camper Hitch
- Bumper Mount Hitch
- 4 x 4 Inch Bumper
- 100 lbs TW
- 3500 lbs GTW
- 2 Inch Hitch
- Bolt-On
- Ultra-Fab Products
more information >
Product Page this Question was Asked From
Adjustable Width Trailer Hitch Receiver for RVs, 22" to 72" Wide
- RV and Camper Hitch
- Frame Mount Hitch
- 22 - 72 Inch Wide Frame
- 350 lbs TW
- 3500 lbs GTW
- 2 Inch Hitch
- Bolt-On
- Weld-On
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Will the Draw-Tite Trailer Hitch Fit a 2022 Volvo XC90 Recharge
- Article: Trailer Wiring Diagrams
- Q&A: Typical Trailer Suspension Hanger Spacing Relative to Leaf Spring Size
- Article: How to Charge a Trailer Battery While Driving: 3 Common Problems (And How to Fix Them)
- Q&A: Best Upgrade for Dometic 310 Part-Timer RV Toilet
- Q&A: How To Connect A Dometic 310 RV Toilet To A Supply Line That's Too Far Away
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Replacement Hub Needed for Lippert 122093 Hub on 5,200 lbs Axle
- Q&A: How To Activate 12V Trailer Charge Circuit On 2019 Ford Super Duty With Factory 7-Way
- Article: 2023 Best Gifts for Outdoor Enthusiasts
- Q&A: Trailer Hitch Recommendation for Towing Jet Ski Trailer with a 2017 Hyundai Elantra
- Article: How Harvest Hosts Is Becoming the New Standard of the Camping Industry
- Article: How to Replace or Install an RV Roof Vent