Trailer Wiring for 2014 Toyota 4Runner to Use Harmar Powerchair Lift
Question:
My Harmar Powerchair lift is wired for a previous 4Runner. Please advise me the proper writing harness I need?
asked by: Cecelia B
Expert Reply:
I have a solution for you, but you will have to remove the connectors on your powerchair lift and wire it to a 7-way instead like the # A7WCB so that you can then install a 7-way on your 2014 Toyota 4Runner to match. The colors for the 4-way connector in your hand will match the color pin outs in the 7-way diagram I attached. You'll have to determine which of pins on the 2-way carry the power and ground and run them to the correct pins on the diagram as well.
Assuming your 2014 4Runner has no trailer wiring you'll need to first start with a 4-way like the part # C59236 and then from there convert it to a 7-way with the # 37185. The 4-way would plug right into the 7-way adapter 4-way connector and then you'd need to run a length of 10 gauge wire like part # 10-1-1 from the black wire through a breaker like part # 9510 to the positive post of the vehicle battery and you'd be set.
Products Referenced in This Question
Adapter 4-Pole to 7-Pole and 4-Pole
- Trailer Wiring
- Wiring Adapters
- Multi-Function Adapter
- 4 Flat
- Plug and Lead
- 4 Flat
- 7 Round - Blade
- Hopkins
more information >
40 Amp In-Line Circuit Breaker - Perpendicular Mount Bracket
- Accessories and Parts
- Wiring
- Circuit Breaker
- 40 Amp
- Pollak
more information >
Curt Powered Tail Light Converter with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Converter
- Universal Fit
- 4 Flat
- CURT
more information >
Product Page this Question was Asked From
7-Way Round RV Style Trailer Connector - Trailer Side
- Trailer Wiring
- Trailer Connectors
- Trailer End Connector
- Plug Only
- 7 Round - Blade
- Optronics
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: How to Tell If MORryde Rubber Equalizers Will Fit Trailer
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Correct Replacement for AL-KO 7230 Hub/Drum and Brakes
- Q&A: Is Bow in 3,500 lb Trailer Axle Enough Camber for Loaded and Unloaded Trailers
- Q&A: One Inch Wide Trim For Horse Trailer
- Q&A: How to Wire a New 4-Way to a Sea Doo Trailer that Has Double Wires
- Article: Must Have RV Accessories that Will Make or Break Your Trip
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Q&A: When to Replace Dexter Nev-R-Lube Bearings
- Q&A: Trailer Tire Size to Replace 8.75R16.5 Tires
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: Trailer Wiring Diagrams
- Article: How to Choose the Right Trailer Hitch Class
- Article: Choosing the Right Suspension Kit for Your Truck and Trailer