How Do You Mount the Tow-Rax Helmet Hanger # TWSPHHA
Question:
How does this hanger MOUNT? Tow-Rax Helmet Hanger - Aluminum - 6inch Long x 4inch Tall x 4inch Deep Code:TWSPHHA I desire to get 2 for tour bike helmets to mount on wall in garage...
asked by: Jim F
0
Expert Reply:
I went out to the warehouse and pulled a Tow-Rax Helmet Hanger, # TWSPHHA, to determine how to mount it. It does not come with its own hardware so you will need to use your own. Drilling into the 4x4 inch square metal base is required. Otherwise you can mount it however you would like. If you are looking for something that is corrosion resistant and light weight, this is the hanger for you.
expert reply by:
Michael H
0
Product Page this Question was Asked From
Tow-Rax Helmet Hanger - Aluminum - 5" Long
- Trailer Cargo Organizers
- Hooks and Hangers
- Hose Hanger
- 4 Inch Wide
- 4 Inch Tall
- Recreation
- 6 Inch Long
- Drilling Required
- Tow-Rax
more information >
Continue Researching
- Q&A: Towing Capacity and Weight Distribution for 2017 Jeep Wrangler
- Q&A: Options for Replacing Lippert Power Drive Tongue Jack 1817941
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Rust Prevention
- Q&A: Does The Manager30 Replace Solar Panel Controller
- Article: Top 10 Upgrades for Your Camper
- Q&A: What is the Mounting Hole Size on E-Track
- Q&A: What Mounting Hardware Is Required To Install Tow-Rax L-Track TWSP24TA On Trailer?
- Q&A: What Screws To Use When Installing E-track To the Side Of Aluminum Trailer Frame
- Q&A: E-Track Recommendation for 5 x 8 Haulmark Transport Deluxe Cargo Trailer
- Article: RV Cell Boosters, How Do They Work?
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: How to Install E-Track in 3 Easy Steps