Troubleshooting Trailer Lights Not Working Properly for 2003 Chevy Silverado Factory 4-Way
Question:
So there seems to be a multitude of problems. If my headlights are off, -hazards work ok -right blinker works on vehicle, but not trailer. -left blinker works on both trailer and truck. If my headlights are on: -Hazards just stay solid on truck, trailer, and dash indicators. -Right blinker works on truck only -left blinker, all lights solid including left display on dash. 2003 Chevy Silverado 1500. No issues with indicators or lights when no trailer is hooked up, but has the same problem when any 4 pin trailer is plugged in. Any input would be greatly appreciated.
asked by: Dan
Expert Reply:
If the issues you described are happening when any 4-Way trailer connector is hooked up, we at least know the problem is somewhere on your 2003 Chevy Silverado (we don't need to worry about the wiring on the trailer).
What I recommend doing first is simply visually inspecting the 4-Way connector on the truck. Look for any debris or corrosion built up inside the pins that needs to be cleaned out. Corrosion inside the pins can lead to a short, which would explain the crossed-up circuits that are showing themselves when turning on the headlights in the Silverado.
If this doesn't resolve the issue then there's something going on with the factory wiring. You can try tracing the wiring as far up the truck as you can from the back of the 4-Way connector, looking for any pinched, exposed, or damaged portions that need to be replaced.
It will probably be pretty difficult to give an in-depth inspection to the factory trailer wires, so your best option may be to simply install a hardwire harness like the Tekonsha # 18252 that you can use to splice into the tail light wiring. This will bypass the factory harness altogether and since you know the tail light circuits are working on the Silverado (since the lights work fine without a trailer attached), this will work great.
Products Referenced in This Question
4-Way Flat Trailer Connector w/ 72" Harness, Circuit Tester and Wire Taps
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- No Converter
- 6 Feet Long
- Universal Fit
- 4 Flat
- Tekonsha
more information >
Product Page this Question was Asked From
- Trailer Wiring
- Trailer Connectors
- Trailer End Connector
- 0 - 5 Feet Long
- Plug and Lead
- 4 Flat
- Draw-Tite
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Does The Draw-Tite trailer Hitch Receiver Come With One Or Two Hitch Pin Holes
- Q&A: Replacement Hub and Drum Assemblies for AL/KO 8460 Hubs and Drums
- Q&A: Replacement Zerk Fitting Recommendation for Dexter EZ Lube Spindle
- Article: Trailer Wiring Diagrams
- Q&A: Can 12 Volt Accessory Circuit of Trailer Wiring Keep 10 Amp Breakaway Battery Topped Off
- Q&A: Recommended Roof Rack Crossbars for Lance Cab Over Camper With Factory Tracks
- Q&A: Can You Install a 5th Wheel Hitch On a 2021 GMC Sierra 2500
- Q&A: 4-Way Trailer Connector that has 5 Wires
- Article: How to Measure for Trailer Hitch Drop
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: Trailer Tire Sizing
- Article: Brake Controller Installation: Starting from Scratch
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Article: Troubleshooting 4 and 5-Way Wiring Installations