Bayonet Termination Lug Fitting for Attaching to Pipe with 3.5 inch Outer Diameter
Question:
Quick follow up. Is this part PVC or ABS?
asked by: Robb S
0
Expert Reply:
Since your current pipe has a 3-1/2 inch outer diameter it most likely has a 3 inch inner diameter (measure this to be sure) which would mean that you'd need a 3 inch spigot to lug fitting adapter like part # T1029-1 as this will slip into the pipe and give you the type standard lug fitting for the standard size bayonets to attach to.
expert reply by:
Jameson C
0
Products Referenced in This Question
Valterra RV Sewer Termination Adapter - 3" Lug Fitting to 3" Spigot
- RV Sewer Hose Fittings
- Sewer Adapters
- Termination Adapters
- Lug
- Spigot
- Sewer Hose to Slip Hub
- 3 Inch Diameter
- 3 Inch Diameter
- Valterra
more information >
Product Page this Question was Asked From
Valterra RV Sewer Termination Adapter - 3" Lug Fitting to 3" Hub
- RV Sewer Hose Fittings
- Sewer Adapters
- Termination Adapters
- Hub
- Lug
- Sewer Hose to Sewer Outlet
- 3 Inch Diameter
- 3 Inch Diameter
- Valterra
more information >
Continue Researching
- Search Results: bayonet fitting
- Q&A: Fittings Needed To Go From 3" MPT Threaded Sewer Pipe To 3" Bayonet Fitting
- Shop: Camco RV Sewer Hose Straight Adapter w/ Lug and Bayonet Fittings - 5" Long
- Shop: Camco RV Clear Sewer Extender Adapter - 3.5" - Clear
- Shop: Valterra RV Sewer Termination Adapter - 3" Lug Fitting to 3" Hub
- Q&A: Can 17-RPM Lift Motor for Fan-Tastic Vent B Series Be Used Instead of 7-RPM Lift Motor
- Q&A: Glue to Use to Connect RV Sewer Pipe
- Article: Trailer Wiring Diagrams
- Q&A: What Year Did The Chevrolet/GMC OEM Prep/Puck System Change For The Silverado/Sierra HD Trucks?
- Q&A: USA Made Bearing Kit For An AL-KO 4,400 lb Axle
- Q&A: Adapter and Re-Wiring Kit for Lance Truck Camper with Round Pin 7-Way Plug
- Q&A: What To Do When The Bayonet Lugs Break Off Of The Sewer Fitting
- Article: Converting Your RV Water Heater to Tankless
- Article: RV Propane 101: How Does My RV's Propane System Work?
- Article: Adding Electric Over Hydraulic Disc Brakes
- Article: How Your RV Water System Works: A Complete Newbie's Guide
- Article: Best Camper Jacks
- Article: Brake Controller Installation: Starting from Scratch
Rich
7/24/2020
Hi. I have a 2004 Sunseeker and the sewer outlet is a bayonet 3" connector. One of the little plastic stubs broke off so my sewer hose connection is not as tight as it would normally be with 4 stubs. What are your recommendations for putting a new fitting in place? How does the old one come out? Do I need some sort of chemicals to loosen the glue and pull it out or can I just twist on a new fitting and glue it in place over the old fitting? Should I cut the old one out? Thanks