Bolt Hole Pattern of Polar Hook and Keeper for Enclosed Trailer Door 383400
Question:
are the hole pattern on the door hook and keeper all the same?
asked by: Barry M
0
Expert Reply:
They are indeed. Vertically, the holes of the # 383400 hook and keeper are 1 inch apart and 2-5/16" apart horizontally as shown in the photo I've edited for you. If you click the provided link, you can see an installation video.
expert reply by:
Mike L
0
Product Page this Question was Asked From
T-Style Hook and Keeper Door Holder for Trailer Rear or Side Door - 4" Hook - Zinc Plated
- Trailer Door Holders
- Hook and Keeper
- T-Style Hook
- 4 Inch Hook
- 2-5/16 x 1 Inch Hole Spacing
- Steel
- Polar Hardware
more information >
Continue Researching
- Q&A: How to Determine Hanger Spacing on a Tandem Axle Trailer
- Q&A: Outside Dimensions of Global Link Ultra E Pro Electronic Lock for Travel Trailer
- Q&A: How Can I Verify If The Global Link Ultra E Pro Will Fit My 2020 Thor Quantum PD31?
- Q&A: Replacement Door Latch for 1999 Feather Lite 9417
- Q&A: Determining Trailer Weight Capacity that has Two 7,000 lb Rated Trailer Axles
- Q&A: Replacement Screws Needed to Install Dual Cams on the Reese Strait-Line
- Article: Trailer Wiring Diagrams
- Q&A: Torque Spec for Tightening Nuts of 1/2 inch Diameter Trailer Suspension U-Bolts
- Article: Determining Trailer Tongue Weight
- Article: Choosing the Right Suspension Kit for Your Truck and Trailer
- Article: How to Install E-Track in 3 Easy Steps
- Article: 2 Steps for Finding the Right Weight Distribution Hitch Size
- Article: The Best Trailer Tongue Locks for Preventing Trailer Theft
- Article: 4-Step Guide to Installing RV Solar Power