Mounting Hardware Availability for the Redline Replacement Handle Latch for Cam-Door Lock
Question:
Hi do you have mounting bolts and nuts for this?
asked by: Eddie
0
Expert Reply:
I have some information that will help, but we do not carry the mounting bolts or nuts for the Replacement Handle Latch, # 158-101. I spoke with my contact for Redline and he said this latch uses 3/8 inch bolts that can be found at any local hardware store. I would recommend using carriage bolts. Carriage bolts will fit in the square mounting holes on the latch and are a good theft deterrent.
expert reply by:
John H
0
Product Page this Question was Asked From
Replacement Hasp for Polar Cam-Action Latch Kits - 1" Wide - Zinc-Plated Steel
- Trailer Door Latch
- Hasps
- 2-Hole Hasp
- Steel
- Lock Not Included
- 5-1/8 Inch Long
- 4-1/4 Inch Hole Spacing
- 1 Inch Wide
- Polar Hardware
more information >
Continue Researching
- Q&A: Recommended Replacement For A Furrion DV7200 RV Stereo System
- Q&A: Will the AT91367 Replace an Atwood 93257 Circuit Board?
- Q&A: Troubleshooting Curt Triflex Brake Controller that Is Flashing Numbers Randomly without Trailer
- Q&A: Replacing a 4-Way Connector on Trailer with 7 Wires
- Q&A: 4-Way Trailer Wiring Recommendation for 1993 Ford E-350 Van
- Q&A: Recommended Replacement Entry Door Latch for Fastec 23348 CR6
- Q&A: Solution for Replacing Dexter 8-222 Trailer Hubs and Bearings
- Article: Trailer Tire Sizing
- Article: Installing an Electric Brake Controller on 2007-2013 GM Full-Size Truck or 2007-Present GM SUV
- Article: Trailer Maintenance Schedule
- Article: How to Choose the Best Tonneau Cover
- Article: What To Look For When Buying Ratchet Straps
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How to Correct Noise from Exhaust Rattling Against a Trailer Hitch