Diameter and Height of the Replacement Miter Gear for Dutton-Lainson Trailer Jacks
Question:
What is the Dia. and Height of this gear and how many teeth
asked by: George N
0
Expert Reply:
I went out to the warehouse and measured the gears for the Replacement Miter Gear for the Dutton-Lainson Trailer Jack. The diameter of both gears is 1-1/8 inches. The height of the taller gear with the circular center is 1/2 inch and the height of the smaller gear is 13/32 inch. Both gears have 12 teeth.
I have included a video that shows the measurements that I took for you.
expert reply by:
John H
0
Product Page this Question was Asked From
Replacement Miter Gear Kit for Dutton-Lainson Trailer Jacks - 600 - 1,000 lbs. (1997 and Newer)
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Motor and Gear Parts
- Gears
- Dutton-Lainson
more information >
Continue Researching
- Q&A: Is The Dutton-Lainson Replacement Mounting Hardware DL22443 Marine Grade?
- Q&A: Installation Information for the Replacement Cables for Enclosed Trailer Ramp Spring # ERS160D96
- Q&A: How Does B&W Silencer Pad BWTS35020 Install
- Article: Most Popular Wheel Bearings
- Q&A: Air Bag Suspension Kit and Air Compressor for a 2022 GMC Sierra 2500
- Q&A: Dimensions of the Parts Included in the Dutton Lainson Miter Gear Kit # DL22439
- Q&A: 7-Way Trailer Connector for 2019 Toyota Tacoma
- Q&A: Replacement Gear Kit DL22439 For Dutton-Lainson Boat Jack
- Article: Trailer Jacks
- Article: 7 Common Questions Everyone Has About Trailer Tires