SewerSolution Macerator System for RV Waste Metal Inlet Inner and Outer Diameter
Question:
I need to connect this to a barbed fitting on a home made black water transportation tank. What size the ID on the flared end of the hose? The host itself is I think 3/4inch but the flaring they did on the end makes it.... not that.
asked by: Tyler
0
Expert Reply:
I contacted SewerSolution and the inner diameter of the metal inlet on the hose of the SewerSolution Macerator System for RV Waste Tanks part # SS01 is 3/4" the outside diameter is 7/8".
expert reply by:
Heather A
0
Product Page this Question was Asked From
SewerSolution Macerator System for RV Waste Tanks - Bayonet Fitting and 4-in-1 Adapter - 10'
- RV Sewer Hoses
- Drain Hoses
- 10 Feet Long
- SewerSolution
more information >
Continue Researching
- Article: Cleaning Your RV Black Water Tank in 4 Easy Steps
- Article: Tire TLC: How & When to Check Your RV/Trailer Tire Pressure
- Q&A: Replacement 8 Lug Wheel Recommendation for a Keystone RV
- Q&A: Does Truck with 6-1/2 ft bed Have to Use Slider Hitch for Turning Clearance with Fifth Wheel Hitch
- Q&A: How to Connect Wiring for Extend/Retract Switch for Lippert Electric Trailer Jack
- Article: How to Dump Black and Gray RV Waste Tanks
- Q&A: Best Cushioned Equalizer Replacement for Equalizer that is 6 inches Wide
- Q&A: Recommended Replacement For A Jensen VR187 RV Stereo System
- Q&A: Recommended 39 Gallon Auxiliary Tank for a 2022 GMC Sierra 3500
- Q&A: Recommended Quad View Camera for Tiffin Allegro Red Motorhome
- Article: How Your RV Water System Works: A Complete Newbie's Guide
- Article: Trailer Hitch Receiver Sizes
- Article: Cleaning Your RV Gray Water Tank in 5 Easy Steps
- Article: Dielectric Grease Review