Troubleshooting Brake Controller Install Where Brakes Lock Up When Brakes are Pressed
Question:
We have installed a Kelsey energize brake system. But every time we apply the brakes the whole trailer brakes lock up. We reset everything and followed the instructions but still they lock up every time
asked by: Trevor C
Expert Reply:
Most likely you have a short between the brake output circuit and a stop/turn circuit of your trailer wiring. You can easily check this though by turning on one of the blinkers to see if the brake pulse with the blinker. It is possible the brake controller is bad though so I can help with how to troubleshoot it.
Testing the brake controller is fairly easy. Sever the blue brake output wire near the brake controller leaving enough room to reconnect it and then apply the manual slide. Using a circuit tester like the Quickee Tester, part # PTW2993, you should get output to the controller side of the wire you severed. If the manual slide activates the trailer brake output wire properly, try the brake pedal. If the brake pedal activates the brake output properly also then the problem is farther back either in the vehicle wiring or on the trailer.
If either the brake pedal or the manual slide are not functioning properly you will need to test the wires going into the brake controller. Make sure you have power entering the brake controller on the black wire. On the red wire you will only want power when the brake pedal is pressed.
If there is power on the red wire before the brake pedal is pressed you have connected the red wire from the brake controller to the wrong circuit. You would then need to find the brake switch wire that has power ONLY when the brake pedal is activated.
If these connections check out and the brake controller is properly grounded then there is possibly a problem inside the brake controller.
I am including a link to a video that will show you how to test the wiring on a brake controller.
Product Page this Question was Asked From
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: Trailer Running Lights Do Not Work but Brake Lights and Turn Signals Do Work
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Brake Controller Installation: Starting from Scratch
- Article: Testing Trailer Brake Magnets for Proper Function
- Article: Troubleshooting 4 and 5-Way Wiring Installations
- Article: Troubleshooting Brake Controller Installations
- Q&A: Will The Curt Dinghy Wire Harness # C96JR Interfere With Activation Of A Blue Ox Patriot
- Q&A: Trailer Turn Signals Both Blink when Just Left Turn Signal is Activated
- Q&A: Trailer Lights Left Side Turn Signal and Brake Lights Not Working
- Q&A: Checking Trailer Lights Without Hooking Up to Vehicle?
- Q&A: Troubleshooting No Running Lights on Trailer but Turn Signals and Brake Lights Work
- Q&A: Parts Needed to Flat Tow 2023 Jeep Gladiator
- Article: Determining Trailer Tongue Weight