Can the Convert-A-Ball Adapter be Used with Hide-A-Ball Gooseneck Hitch on 2001 Chevy Silverado
Question:
Can a cab-c5g adapter be used with a hide a ball installed in a 2001 chevrolet silverado that has been lifted 9 inches from stock height. My bed height is 47 1/2 inches from the ground.
asked by: Anthony M
Helpful Expert Reply:
The only gooseneck hitches that the Convert-A-Ball Cushioned 5th-Wheel-to-Gooseneck Adapter # CAB-C5G is not compatible with can be found on the product page with this text:
Note: This adapter is not recommended for use with Reese Elite Series gooseneck trailer hitches. It is also not recommended for use with factory-installed towing prep packages from Ford 2011 to present or Ram 2013 to present.
This adapter can be adjusted from 12" - 16" tall so you just need to measure from the ground to the bottom of your 5th wheel pin box and if that is within 12" - 16" of the 47-1/2" you measured for the bed height on your 2001 Chevy Silverado then you are good to go. Otherwise you may need to look into raising your trailer some so that it rides level and you get the 5" - 6" of clearance between your bed rails and your trailer overhang.
The easiest way to raise your trailer is by using an over-under conversion kit like part # K71-384-00 for a 2-3/8" diameter axle or part # K71-385-00 for a 3" diameter axle. This raises your trailer equal to the diameter of your axle plus the height of your leaf spring stack.
Products Referenced in This Question
Dexter Trailer Springs Over-Under Conversion Kit
- Trailer Suspension Parts
- Alignment and Lift Kits
- Boat Trailer
- Camper
- Car Hauler
- Snowmobile Trailer
- Utility Trailer
- Double Eye Springs
- Round Axle - 2-3/8 Inch
- Single Axle
- Dexter
more information >
Dexter Trailer Springs Over-Under Conversion Kit
- Trailer Suspension Parts
- Alignment and Lift Kits
- Boat Trailer
- Camper
- Car Hauler
- Snowmobile Trailer
- Utility Trailer
- Double Eye Springs
- Round Axle - 3 Inch
- Dexter
more information >
Product Page this Question was Asked From
Convert-A-Ball Cushioned 5th-Wheel-to-Gooseneck Adapter - 12" to 16" Tall - 20,000 lbs
- Gooseneck and Fifth Wheel Adapters
- Adapts Trailer
- Fifth Wheel Trailer to Gooseneck Hitch
- No Offset
- 20000 lbs GTW
- Bolts Over King Pin
- Adjustable Height
- King Pin Adapters
- Convert-A-Ball
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: Adapters for Towing a 5th Wheel Trailer with a Gooseneck Hitch
- Article: Gooseneck to 5th Wheel Adapters
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: Best 5th Wheel to Gooseneck Adapters (2023)
- Q&A: Does Truck with 6-1/2 ft bed Have to Use Slider Hitch for Turning Clearance with Fifth Wheel Hitch
- Article: Fifth Wheel Trailer Hitch Information and Installation Tips
- Article: 5th Wheel to Gooseneck Adapters
- Q&A: How To Tow a 5th Wheel Trailer Using a Truck with CM Flat-Bed and Recessed Gooseneck
- Article: Trailer Wiring Diagrams
- Q&A: How to Find Gen-Y Gooseneck Pin Box Adapter for a 2021 Grand Design Reflection 31MB
- Q&A: Replacing A Venture CJ13517 Pin Box
- Q&A: Help With Adjusting Pin Box Height When Switching to Gen-Y Gooseneck Adapter
- Q&A: What Does E6 Furrion Thermostat Indicate
- Q&A: Pin Box Upgrade Option For A Leland 7920 Pin Box