What Size Torx Bits are Needed to Install Draw Tite Hitch 75492
Question:
Your video mentions that the bumper fascia requires a Torx T55 bit to remove two of the bolts. Later in the video, when you need to remove the 6 or so bolts on the bumper itself, you state they are Torx, but not which size. Are they T55 as well? It would just be nice to know ahead of time because my collection of Torx bits tops out at T25. thanks
asked by: Michael C
Expert Reply:
Draw Tite states that to install the part # 75492 that you mentioned you'll need Torx bit sizes of T55 and T50.
The wrench sizes aside from that you'll need are 8 mm, 13 mm, and 3/4 inch.
I attached an install video for this hitch for you to check out as well.
Product Page this Question was Asked From
Draw-Tite Max-Frame Trailer Hitch Receiver - Custom Fit - Class IV - 2"
- Trailer Hitch
- Custom Fit Hitch
- Class IV
- 600 lbs TW
- 6000 lbs GTW
- 6000 lbs WD GTW
- 2 Inch Hitch
- 600 lbs WD TW
- Concealed Cross Tube
- Draw-Tite
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Trailer Hitch Recommendation for a 2011 BMW X5
- Q&A: Recommended Items Needed to Tow with a 2005 BMW X5
- Q&A: Is Drilling into Frame Required for Installation of the Curt Class III Trailer Hitch on 2003 BMW X5
- Q&A: Can I Install A Trailer Hitch On My 2003 BMW X5?
- Q&A: Can RV Covers Be Left On Travel Trailer While Driving
- Article: What Do I Need To Tow A Trailer?
- Article: Types of Bumpers
- Q&A: Recommend Hitch, Wiring Harness, and Brake Controller for a 2002 BMW X5 3.0 Towing Airstream Trailer
- Q&A: Comparing the Draw-Tite Trailer Hitch # 75600 and the Curt Trailer Hitch # 13077 for a 2015 BMW X5
- Article: Rooftop Cargo Carriers
- Article: Trailer Hitch Installation Tips
- Article: Rust Prevention