Dimensions From Pin Hole to Platform for Clearance on Draw-Tite Drawbar for 1-1/4" Hitch Receiver
Question:
Need to clear a bumper. What is the distance from the pin hole to the car-side leading edge of the ball moint plate
asked by: Stephen W
0
Expert Reply:
From the center of the hitch pin hole to the back of the platform for the Draw-Tite Drawbar # 36061 measures about 7" (see attached).
expert reply by:
Jon G
0
click to enlarge
Product Page this Question was Asked From
Draw-Tite Drawbar for 1-1/4" Hitches - 3-1/8" Rise - 9-3/4" Long - 3,500 lbs
- Trailer Hitch Ball Mount
- Fixed Ball Mount
- No Ball
- 3/4 Inch Ball Hole Diameter
- Steel Shank - Gloss Black
- Rise - 3 Inch
- Fits 1-1/4 Inch Hitch
- 3500 lbs GTW
- Class II
- Draw-Tite
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Article: How to Measure for Trailer Hitch Drop
- Article: My Trailer Hitch Doesn't Fit
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Ball Mount Basics: Weight Capacity, Class, and Size
- Article: Trailer Wiring Diagrams
- Q&A: Trailer Hitch and Wiring Recommendation for 2018 Ford Focus ST Hatchback
- Article: How to Choose a Cargo Carrier That Will Clear a Rear Mounted Spare Tire or Bumper
- Q&A: What Kind of Hardware Should I Use For My Trailer D-Ring Tie Downs?
- Q&A: Locating Factory Weldnuts on 2003 Volvo V70 to Install Curt Trailer Hitch # C12318
- Q&A: Will the Wiring Harness # C59496 Fit on a 2006 Volvo XC70
- Q&A: Can Trailer Hitch Extender hes0 Be Used for Towing with a 2007 Ford Explorer
- Q&A: Trailer Hitch for a 1997 Toyota Camry LE