How To Install a Tekonsha Wiring Harness On a 1995 Jeep Cherokee
Question:
Will this wire right into the rear harness?
asked by: Norman B
0
Expert Reply:
In order to install the Upgraded Circuit Protected Tail Light Converter Hardwire Kit part # 119178KIT on your 1995 Jeep Cherokee you will need to run each of the signal wires to the correct circuits which the best place to access these will be directly behind the taillights. If you need help with this you can use the video I have attached for you as a reference though it is not on a Jeep Cherokee. I am not sure what harness you are referring to but the above is the correct method to install this harness on your Jeep Cherokee.
expert reply by:
Conner L
0
Product Page this Question was Asked From
Tekonsha Tail Light Converter with 4-Way Flat Trailer Connector and Install Kit
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Converter
- 1-1/2 Feet Long
- Universal Fit
- 4 Flat
- Tekonsha
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Install Video that Can be Used for 2007 Toyota Avalon for Trailer Wiring
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Can the Bulldog Powered-Drive Kit be Used on Any Jack
- Q&A: Bulldog Powered-Drive Kit Compatibility With 12K Ram Landing Gear
- Q&A: Bypassing TIPM for Trailer Wiring Fix on 2004 Dodge Ram 1500
- Article: My Trailer Hitch Doesn't Fit
- Q&A: Mounting the Replacement Wiring Harness For Factory 7-Way On a 2008 Toyota 4Runner
- Q&A: How Do You Disconnect Factory 7-way Connector On 2007 Toyota 4Runner To Install Hopkins HM43374?
- Q&A: Is There a Replacement for a Trimark 030-0900 Door Latch
- Article: Trailer Wiring Diagrams
- Article: How to Choose the Right Trailer Hitch Class
- Article: How to Measure for Trailer Hitch Drop
- Article: Flat Towing Package for 2014-2018 Jeep Grand Cherokee