How Does License Plate Install Hardware part # CR80230 Install on Bracket
Question:
How do I fasten these to my vehicle? Does the flat part of the plastic nut go behind the holder that the plate will be fastened to? Flat part against vehicle or the fluted part against vehicle. Thanks for the help.
asked by: Sue
0
Expert Reply:
On the license plate bracket of your vehicle there will be square holes that the # CR80230 will pop into (see picture). The portion that pops into the bracket is the four triangular pieces. Once it's installed it becomes a backing plate essentially for the hardware to screw into once passed through a license plate.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Steel Fasteners for License Plates and License Plate Frames - Standard - Qty 4
- Accessories and Parts
- License Plates and Frames
- Fasteners
- Non-Locking
- Standard
- Cruiser
more information >
Continue Researching
- Q&A: Replacement Spring Kit for Power Gear Jack on 2003 Fleetwood Southwind 37U
- Q&A: Will etrailer.com Electric Brakes # AKEBRK-12 Replace Dexter 12K Brakes on Trailer
- Q&A: Help Picking Out Replacement Hub for TDE 11033
- Q&A: Replacement Hub Assembly for T.D.E. 11033
- Q&A: Hole Size Needed for Cruiser CR80230 License Plate Mounting Hardware
- Q&A: Resetting the Pin on the LCI Leveling System Remote Control
- Q&A: Determining Correct Oil Bath Seal For Dexter D100G 10000lb Axle
- Article: How to Measure a Trailer Axle
- Article: Most Popular Wheel Bearings
- Article: Trailer Hitch Receiver Sizes
- Article: Trailer Wiring Diagrams