Trailer Hitch Fit for a 2020 Toyota Corolla

Question:

Do you have a tow hitch available for a 2020 Corolla Sedan SE?

asked by: Frankie H

Helpful Expert Reply:

We actually do have a trailer hitch for your 2020 Toyota Corolla Sedan! It is the Class I Draw-Tite Sportframe Trailer Hitch Receiver # 24983 and it has a 1-1/4" hitch receiver.

You did refer to this as a tow hitch so if you planned on using this trailer hitch for towing you also need some wiring and a ball mount kit. I recommend the Tekonsha T-One # 118810 for wiring because of how reliable it is and that it bypasses your OEM wiring so you know your vehicle is protected. For a ball mount you'd need something like the Draw-Tite # 3593 which comes with a hitch pin & clip, as well as a hitch ball like the 1-7/8" # 19256 or the 2" # 19258. I have attached a helpful article and our compatible ball mounts that you can check out.

Please note that when I looked up the online manual for a 2020 Corolla it did state on page 143 that Toyota does not recommend towing with your vehicle. You'd want to keep this in mind when it comes to how you use this trailer hitch.

expert reply by: Jon G

Angelo J.

7/15/2020

Hi I would like to know can 2020 Toyota Corolla SE fit with trailer hitch for Bicycle only. Not need wiring. Thank

Chris R.

7/20/2020

Of course! The Draw-Tite # 24983 will work perfectly with a bike rack for your Corolla SE. There's no need to add wiring to this setup.

Helpful Links

dept-pg-hitch_bike_racks-hs-class_1.aspx

Angelo J.

7/20/2020

I live in Barnegat, New Jersey 08005 where can I find to be installment on trailer hitch on 2020 Toyota Corolla SE around here and how much cost total plus labor? Thanks

Chris R.

7/26/2020

I don't have any specific recommendations for where to have the install done in New Jersey but I can tell you that any local mechanic/shop with a decent reputation will be able to handle the install without issue. The Draw-Tite # 24983 is a pretty simple install (Draw-Tite estimates about 40 minutes beginning to end) so I can't imagine labor will be too much but that will just depend on local rates.

Yorman I.

5/2/2020

Hello, I hope you help me, I want to put a bike rack on the Corolla 2020, but in the installation they talk about drilling a hole, I do not know if this interferes with the warranty of the car.

Chris R.

5/4/2020

The Draw-Tite Hitch # 24983 does require that two holes be drilled into the frame rails for installation. Doing this will not void the vehicle's warranty because of a really nice thing called the Magnusson-Moss Act, which essentially states that the dealer/manufacturer cannot void a warranty simply because you installed an aftermarket component like a hitch. Warranty issues would only come up if those drilled holes actually caused an issue, in which case Draw-Tite would be on the hook.