What Position Should the Hook and Keeper for Enclosed Trailer Doors Be Mounted In
Question:
Am I not mistaken that the holes are 2.5/16 vertical and 1 horizontal? The mount goes up and down correct? It’s taller than wider...
asked by: Robin D
0
Expert Reply:
Correct, the mounting holes on the Hook and Keeper for Enclosed Trailer Doors part # 383400 are 2-5/16" apart top to bottom (vertically) and 1" apart left to right (horizontally). The actual plate measures to be 3" tall x 1-3/4" wide. Therefore, it is taller than it is wider.
I have attached a few photos to clarify the above.
expert reply by:
Conner L
0
click to enlarge
click to enlarge
Product Page this Question was Asked From
T-Style Hook and Keeper Door Holder for Trailer Rear or Side Door - 4" Hook - Zinc Plated
- Trailer Door Holders
- Hook and Keeper
- T-Style Hook
- 4 Inch Hook
- 2-5/16 x 1 Inch Hole Spacing
- Steel
- Polar Hardware
more information >
Continue Researching
- Article: Determining Trailer Tongue Weight
- Q&A: Holding Trailer Doors Open Using Plungers or Hook and Keeper Holders
- Q&A: How to Determine Hanger Spacing on a Tandem Axle Trailer
- Q&A: How to Extend Trailer Tongue By 36 Inches
- Q&A: Dimensions of the Bauer Products Camper Door Lock Face Plate
- Q&A: How Can I Verify If The Global Link Ultra E Pro Will Fit My 2020 Thor Quantum PD31?
- Q&A: Will The Global Link Ultra E Pro Door Lock Fit A 2019 Keystone Springdale Travel Trailer
- Q&A: Determining Trailer Weight Capacity that has Two 7,000 lb Rated Trailer Axles
- Article: Trailer Wiring Diagrams
- Article: What are the Common Types of Propane Fittings Used on RVs?
- Article: How to Use a Roof Rack (Like a Boss)
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Article: Choosing the Right Suspension Kit for Your Truck and Trailer
- Article: How to Install E-Track in 3 Easy Steps