Corrosion On Contacts Inside of Air Lift WirelessAIR Remote
Question:
My remote stopped working because of battery erosion inside terminals so cleaned them up.
asked by: Renn W
Expert Reply:
If the contacts on the battery terminals inside of the remote for your Air Lift WirelessAIR Compressor System became corroded and the remote still does not work once this corrosion was cleaned out then odds are the corrosion has spread to the contacts on the circuit board. If that was the case then you will need to replace the remote, the Replacement Wireless Remote for Air Lift WirelessAIR Compressor System part # AL73002 which is for the Air Lift WirelessAIR Compressor System for Air Helper Springs part # AL74000.
Products Referenced in This Question
Air Lift WirelessAIR Compressor System for Air Helper Springs - Remote - Bluetooth
- Air Suspension Compressor Kit
- Wireless Control
- Dual Path
- Digital Display
- 100 psi
- Air Lift
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: The LCD Display on the Air Lift WirelessAir Remote is not Working Properly
- Q&A: The Remote Says Fail, Is There A Reset On The Air Lift WirelessAIR Compressor System
- Q&A: Pairing the Replacement Wireless Remote to the Air Lift WirelessAIR Compressor System
- Q&A: How To Pair an Air Lift WirelessAIR Remote to Compressor
- Q&A: Air Lift Wireless Remote Control Replacement For Remote 73001 and Pairing Instructions