What to Do with Start Nut When Cutting Support Peg For Stromberg Carlson RV Ladder
Question:
How does the internal nut come out for cutting and re- afterwards? I have 3 to put in. Thanks.
asked by: Larry H
0
Expert Reply:
When trimming the Ladder Support Peg # 8531-B for your Stromberg Carlson RV Ladder # LA-401BA you will first take the cap off the end that attaches to the ladder. With the cap off simply push that star shaped nut further down into the tube before cutting it to your desired length. This will eliminate the hassle of actually removing the nut having to install it back into place.
expert reply by:
Chris R
0
Products Referenced in This Question
Stromberg Carlson Exterior RV Ladder - Aluminum - 99-1/2" Tall - 250 lbs - Black
- RV Ladders
- Exterior Ladders
- Aluminum
- 8 Feet Tall
- Black
- Stromberg Carlson
more information >
Product Page this Question was Asked From
Replacement Standoff for Stromberg Carlson Exterior RV Ladders - Qty 1
- Accessories and Parts
- RV Ladders
- Support Peg
- Stromberg Carlson
more information >
Featured Help Information
Instructions
Continue Researching
- Article: Best Bike Racks for Electric Bikes
- Q&A: 2022 Toyota Highlander Wiring for a 7-Way Blade Connector
- Q&A: How to Wire Break Away Switch on Hopkins Engager Break Away System
- Q&A: Water Heater To Replace Atwood Gc6aa/10E
- Q&A: Is Dometic 6-Gallon RV Water Heater DMC74FR Best Option For Tanked Water Heater
- Q&A: Correct Flat Tow Wiring Harness Didoes for 2022 Ford F-150
- Q&A: Solution for Needing Stoplight Circuit on Difficult to Find Vehicle
- Q&A: Do I Need To Have A 3-Wire to 2-Wire Converter To Flat Tow a 2022 Ford F-150?
- Article: RV Propane Troubleshooting | Common Propane Issues and How to Solve Them
- Article: Trailer Tire Sizing
- Article: Stability Control for Heavy Duty Vehicles
- Article: Rooftop Cargo Carriers
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps