Should I Replace My Brake Magnet If It's Cracked

Question

Question:

Will a crack in the material between the inner metal surface and outer metal surface affect the operation of the magnet.10 Al-Ko Brake Magnet

asked by: Gordon

0

Expert Reply:

If there are any visible signs of wear on the brake magnet part # BP01-110 or any other brake magnet it is time to replace it.

I have attached a help article that will help you test your brake magnets operation however, if they are cracked I recommend replacing them anyway.

expert reply by: Heather A

0

Answer 1

Are there any visible signs of wear on the magnets like exposed windings then that would indicate they need replacing. Magnets can go bad without showing visible signs of wear though. To see how to troubleshoot them check out the help article I…

view full answer...

Answer 2

There really isn't a solution we can provide aside from replacing the spindle since yours is damaged beyond repair. Since you have a 3,500 lb EZ lube axle the correct replacement spindle would be the part #TRU74FR. I recommend taking it to a shop…

view full answer...

Answer 3

You do not have to grease the grease seal like the part #RG06-050 that you referenced when installing them.

view full answer...

Answer 4

Yes, the item listed for 3,500-lb axle, #RG06-050, should be what you are looking for. This should cover axels from 3,500 to 5,000 lb. as long as it has 12" hub, Double Lip - ID 1.719" / OD 2.565". I have attached a few links for tool…

view full answer...

Answer 5

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 6

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Answer 7

The correct replacement master cylinder kit we have for your Demco setup is the part #DM5918 which comes with the lock out replacement.

view full answer...

Answer 8

If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…

view full answer...

Answer 9

To tow your trailer that uses an RV style 7-way blade style connector with your semi that has a 7-pin connector, you need to construct an adapter that will also combine the brake signal into the right and left directional signal pins. This can be…

view full answer...

Answer 10

I would be happy to help you set up your 2022 Toyota Highlander to haul your new travel trailer. The wiring harness you currently have controls your trailer's lighting functions only. You do not need to rewire your Toyota you just need another…

view full answer...

Answer 11

Thank you for purchasing from etrailer! You did a great job selecting compatible parts. When using Leaf Springs #e64SR with the #AP233 Equalizer Kit and the #H248 Hanger Kit, there should be 29-1/2" between the front and center hangers and…

view full answer...

Answer 12

The old version of the #HBA-CAM used 4 wires, but the product was updated awhile back and now uses only two wires as shown in the photo on the product description page. The white wire from the HBA-CAM would tap into the white ground wire and the blue…

view full answer...

Should I Replace My Brake Magnet If It's Cracked

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching