Will the Universal-Design Rocker Switch With Dual Actuators Install In a Standard Switch Cutout
Question:
Is this a double switch, that is the same size as 1 standard acc. Switch
asked by: Jason H
Expert Reply:
The Universal-Design Rocker Switch part # PK34312 is a dual actuated switch that gets installed in a 0.830" wide x 1.450" tall cutout which is a very common size. Therefore, yes the above will install inside a standard 12 volt rocker switch cutout. For reference, the Universal-Design Rocker Switch part # PK34360 is a single actuated switch that gets installed in the same 0.830" wide x 1.450" tall cutout as the above.
The Female Spade Terminal Quick-Disconnect part # DW01899-1 is what you would want to use to attach to the back of the switch.
Products Referenced in This Question
Female Spade Terminal Quick-Disconnect - 16-14 Gauge - Fully-Insulated PVC - Qty 1
- Wiring
- Wire Connectors
- Quick Disconnects
- 16-14 Gauge
- Deka
more information >
Universal-Design Rocker Switch - SPST - On-Off - 12 Volt - 20 Amp - 3-Blade - Red Pilot Light
- Accessories and Parts
- Wiring
- Switches
- Rocker Switches
- 20 Amp
- Pollak
more information >
Product Page this Question was Asked From
Universal-Design Rocker Switch - Dual Actuators - DPDT - High-Off-Low - 12 Volt - 20 Amp
- Accessories and Parts
- Wiring
- Switches
- Rocker Switches
- 20 Amp
- Pollak
more information >
Continue Researching
- Article: RV Sway Control, Stabilization, and Suspension Enhancement
- Q&A: Spade Terminal Size on Mini-Illuminated 12V Switch 12765
- Q&A: How To Attach 7 Pole Wiring Mounting Bracket to Draw-Tite 76227 on 2019 Subaru Outback Wagon
- Q&A: How Does the Universal-Design Rocker Switch Wire to Circuits
- Article: Flat Towing Package for 1998-2006 Jeep Wrangler
- Q&A: Replacement Awning Switch for 2020 Keystone Outback
- Q&A: 2006 Fleetwood Southwind Single Slide Out Momentary Switch Replacement
- Q&A: How to Adapt a 7-Way Round Connector to a 7-Way Flat
- Q&A: Wiring an Up/Down Switch to Hydraulic Pump on a Dump Trailer
- Article: Brake Controller Installation: Starting from Scratch
- Article: Trailer Wiring Diagrams