Is There Trimming Involved to Install Draw Tite Hitch # 76217 on 2018 Chevy Equinox Diesel
Question:
Is there a hitch that allows u to install without have to cut the fascia /bumper. If i have to cut it out. Does it come with instructions and is there an that goes where u cut. What does it look like
asked by: Jason
Expert Reply:
The only hitch we have for your 2018 Chevy Equinox diesel is the Draw Tite part # 76217 which does require fascia trimming. The trimmed section won't be visible from the rear of the vehicle though. This hitch does come with instructions that show where to trim it which are linked to this page as well.
I attached a picture that shows where the trimming will be for you to check out as well.
Product Page this Question was Asked From
Draw-Tite Max-Frame Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- Custom Fit Hitch
- Class III
- 675 lbs TW
- 4500 lbs GTW
- 4500 lbs WD GTW
- 2 Inch Hitch
- 675 lbs WD TW
- Concealed Cross Tube
- Draw-Tite
more information >
Featured Help Information
Instructions
Continue Researching
- Article: Trailer Tire Sizing
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Q&A: Replacement Bearing Kit Recommendation for Viking Popup Trailer with Dexter EZ Lube Spindles
- Article: Can You Flat Tow a Ford Escape?
- Article: Trailer Maintenance Schedule
- Q&A: Complete Towing Setup for a 2018 Chevrolet Equinox Diesel
- Q&A: No Relays Found When Installing Curt Wiring for Factory Tow Package on 2019 GMC Terrain
- Q&A: How to Select Trailer Tires with Correct Load Range Rating for Trailer Gross Weight
- Q&A: How Much Does the Curt Trailer Hitch # C45019 Weigh
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Are Extra Relays or Fuses Needed to Use Curt Trailer Wiring Harness on 2020 GMC Terrain
- Article: Rust Prevention
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: How to Use a Roof Rack (Like a Boss)