Can 2015 Smart Fortwo be Towed on Tow Dolly

Question

Question:

Can you use a Road Master tow dolly with a 2015 Smart fortwo? Ive seen pictures with it pulled on front ways and backed on.

asked by: Brian K

0

Expert Reply:

I found the owners manual of your 2015 Smart fortwo and they state that for tow dolly purposes you are supposed to have the rear axle on the dolly and the front axle on the road. Check out page 171 of your manual for more info and procedures. You can then use a tow dolly like the Roadmaster part # RM-2050-1.

expert reply by: Jameson C

0

Answer 1

You will need to use a circuit tester, item #PTW2992 if needed, to test the pins in the 6-Way connector at the rear of your vehicle. Ground the alligator clip to the vehicle chassis and touch the test light to the center pin. If the light in the…

view full answer...

Answer 2

The Chevy Spark can be flat towed only if it has a manual transmission. To flat tow the Spark, you will need a base plate, I recommend Blue Ox Base Plate Kit, #BX1725. For the tow bar, I recommend The Blue Ox Avail Tow Bar, #BX7420. This non-binding…

view full answer...

Answer 3

I spoke with my contact at Roadmaster and he said that on a Roadmaster Tow Dolly Trailer like the #RM-2050-1, the serial number will be located on the tongue of the trailer or on the passenger side, main base, facing forward.

view full answer...

Answer 4

Yes, they are made of wood. No, but the Roadmaster Tow Dolly Ramp Wear Strip and Spacer Plate Replacement Kit part #RM-2000-25 aren't an upgrade, they are the same wear plate that would have came with the trailer when purchased new. They are made…

view full answer...

Answer 5

The wear plate in the Roadmaster #RM-2000-25 is 16" long x 8" tall and the holes are spaced 14-1/2" apart. The spacer plate is 4" long x 3" tall and 1/4" thick.

view full answer...

Answer 6

The first thing you'll need to flat tow your 2015 Chevy Malibu LS is a base plate kit like the Roadmaster part #RM-523178-5 that is a confirmed fit. In addition to the base plates, you will also need a compatible tow bar, safety cables, lighting,…

view full answer...

Answer 7

In order to use the Custer Wireless LED Light #LIW-LDTL-7B you just need a standard 7 way connector. I've attached a photo of what a standard 7 way plug is going to be wired like, as well as one of our helpful articles on wiring a 7 way plug that…

view full answer...

Answer 8

The Custer Wireless LED Tow Bar Light part #LIW-LDTL-7B and Pilot Magnetic Tow Lights part #RM-2120 are both excellent options for magnetic tow dolly lights which are wireless so no wires between the vehicle and toad are needed. In regard to powering…

view full answer...

Answer 9

You still will be able to jack up your 2010 Honda Accord with the Draw Tite hitch #24899 installed. If the rear jack point is inaccessible you'd be okay to use the hitch instead.

view full answer...

Answer 10

Hello Steven. The mounting studs that come with the #AKEBRK-35L-SA technically are removable. You would probably have to knock them out with a hammer or a rubber mallet if you want to remove them. These will bolt up to a standard 4 bolt brake flange,…

view full answer...

Answer 11

You can flat tow a 2014 Nissan Sentra with all wheels on the ground as long as it has a manual transmission. If yours has an automatic transmission then the vehicle must be placed on a tow dolly such as #RM-2050-1. If you have the manual transmission…

view full answer...

Can 2015 Smart Fortwo be Towed on Tow Dolly

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching