Crossbar Load Stop that Fits Yakima Jetstream Crossbar

Question

Question:

Are the #602 compatible with Yakima JetStream PAIR SKU: #8000427? Thank you!

asked by: Elsa

0

Expert Reply:

Yakima actually makes a load stop that was designed specifically to fit the Yakima Jetstream crossbars as the part # Y01161. The channel nuts are very similar in size to the # S602 you referenced so most likely these would fit also although it's not been tested.

expert reply by: Jameson C

0

Answer 1

You would want to go with a double lip seal since your trailer is a boat trailer that will be submerged underwater. For that you would want the part #168233 which is a double lip seal in the exact dimensions as you would need. We don't have a…

view full answer...

Answer 2

The thickness of the Redline Grease Seal #168233 seal is 0.38. However, thickness is not always a dimension associated with picking out a suitable replacement seal. Typically it is the outer diameter and the inner bearing for picking out a…

view full answer...

Answer 3

Yes, I have listed for your below the roof rack systems from Rhino-Rack, Thule, and Yakima that will fit the RetraxPRO XR Hard Tonneau Covers like part #RTT-80243 for your 2019 Ram 1500. Rhino-Rack Vortex Crossbar System part #RRVA180B-RRRLT600…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

I have a solution for you Travis as Pace Edwards does not offer a contractor rack for your 2023 GMC Sierra 1500. Instead you can use the Pace Edwards Full-Metal JackRabbit Retractable Hard Tonneau Cover #311-M-FMCA28A59 with the Thule TracRac SR…

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

Hey Donald, the best Blue Ox weight distribution would be the pat #BXW0550 as it has a perfect tongue weight range for your 450 lb tongue weight trailer.

view full answer...

Answer 8

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 9

Reese has a gooseneck ball that fits the OEM pucks of your 2020 GMC Sierra 3500 with the part #RP23FR but this doesn't have any rise built into it. The ball you mentioned does not fit your truck.

view full answer...

Answer 10

Curt recommends the use of 250 ft/lbs of torque when tightening the nuts of their hitch balls with a 1 inch diameter shank like the part #C40034 that you referenced. The general rule is for a 3/4" shank tighten to 150 ft/lbs For a 1" shank…

view full answer...

Crossbar Load Stop that Fits Yakima Jetstream Crossbar

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching