Hubs to Fit Trailer Axle that Has Spindles with Bearing Diameters of 1.25 and 1.75 inch

Question:

Have two old axles I want to put new hubs on, if I could get pointers on what equipment I’ll need. Nothing fancy just needs to work. Would like one axle to have brakes and the other just idler hubs I’ve attached a picture of the axle ends I’ll be putting the hubs on and the measurements are as follows Trailer Hub Outside - In Surface 1 1 1/4” Diameter 2” Long until Taper Surface 2 1 3/4” Diameter 1 1/4 Long until step up Surface 3 2 3/8 Diameter 2 1/4 long 1” of thread at the end of axle Thanks guys!

asked by: Riley M

Expert Reply:

Your spindle dimensions match the 42 spindle which has 1.25 inch and 1.75 inch diameters where the bearings ride. So for a brake hub to fit what you have you'd want the part # 8-201-9UC3-EZ which has a 6 on 5-1/2 inch bolt pattern and then for an idler hub you'd want the # 8-213-5UC1.

Then for a set of brake assemblies we have the # AKEBRK-6 which will fit the hub/drum mentioned.

expert reply by: Jameson C