Using Circuit Tester to Test Trailer Wiring to Find Problem
Question:
driver side trailer light - no brake light, tail light, or turn signal. passenger side working perfectly. I have BTMT15......how do I find problem?
asked by: JIm
Expert Reply:
First thing you should do at this point is test the 4-way of the wiring harness with a circuit tester part # BTMT15 for voltage on all of the right pins when the taillight signals are being applied. Just like in the video I attached.
If the voltage checks out there but the trailer lights still don't function right then the problem is on the trailer wiring. That would mean that problem is either due to a ground issue or a short issue.
Make sure that the trailer side connector are clean and free of corrosion inside and out. The main connector grounds should be attached to clean and corrosion free bare metal surfaces. The light grounds should also be attached to clean and corrosion free bare metal surfaces. If there is anything between a light ground and the metal trailer frame or if the trailer has an aluminum frame, tilt bed, or folding tongue, any of these things can interrupt the ground. Running jumper wires from the light grounds to the main trailer connector ground can help.
If the problem is on the vehicle side then I would first recommend you double check how the harness is installed on your vehicle, make sure all of the connections are good and tight. You should check all towing related fuses and relays as well.
Product Page this Question was Asked From
Digital Multimeter with 42" Long Test Leads - LED Display
- Electrical Tools
- Testers
- Multimeter
- Yellow
- Performance Tool
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Electric Trailer Brakes not Working
- Article: Testing Trailer Brake Magnets for Proper Function
- Q&A: Does The Progressive Dynamics PD4655V Have A Lithium Jumper
- Article: Trailer Wiring Diagrams
- Q&A: Can An A-Frame Trailer Jack Be Wired To The 7-Pole Cable
- Q&A: How to Wire a Trailer with Electric Brakes
- Q&A: Should Electric Trailer Brakes Have Continuity Between The Two Wires?
- Q&A: Troubleshooting EverChill 324-000119 12-Volt Refrigerator WD-282FWDC Not Cooling
- Q&A: Difference Between Dexter Axle Grease Seals 010-036-00 and 010-054-00
- Article: Troubleshooting Brake Controller Installations
- Article: Testing Brake Controls
- Article: How to Charge a Trailer Battery While Driving: 3 Common Problems (And How to Fix Them)
- Article: Brake Controller Installation: Starting from Scratch
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?