Right Rear Turn Signal Out Error on Diode Kit Wiring for 2019 Jeep Wrangler

Question:

I have a 2019 Jeep Sahara with LED lights. Diodes appears to be installed correctly, and all lights are functioning properly...connected to the RV and not connected. However, I am getting a Right Turn Signal Out warning light when I start the Jeep. The turn signal is also giving me a rapid flash when activated as if light is out. Again all is working properly. I have switched the diodes to verify that it was not a diode problem. Any suggestions why I’m getting the warning light on the Jeep? Thanks

asked by: Jeff

Expert Reply:

I forwarded this to my contact at Roadmaster and this is what they send me back:

What is catching my attention is that the dash says the right rear TURN signal is out -- the diodes should be tied into the brake signal wire and the tail light signal wire, not turn. Can you tell me the factory wire colors that the diodes are tied into on the right side? I should the FACTORY Jeep wrangler brake wire color as being green and the tail being white w/orange stripe -- Is that the same as the customers vehicle?

expert reply by: Jameson C