Do I Still need A Load Resistor With CANBUS Error Free Putco Lights
Question:
The Putco Metal 360 LEDs state that they are CANBUS error free...would I still need a resistor spliced in to prevent hyper flashing? Looking for a simple LED upgrade for my 2016 Colorado.
asked by: Patrick H
0
Expert Reply:
The Putco part # P347440A-360 does have a built in load resistor to prevent warning lights on the dash but if you are using these lights for turn signals, it is recommend to use an additional load resistor kit part # DI34ZR. I have attached a diagram for your reference.
expert reply by:
Heather A
0
click to enlarge
Products Referenced in This Question
Load Resistor Kit for LED Turn Signals - 50 Watts - 6 Ohm - Qty 2
- Accessories and Parts
- Trailer Lights
- Load-Resistor Kit
- Diamond
more information >
Product Page this Question was Asked From
Putco Metal LED Bulbs - 7440 - 360 Degree - 15 Diodes - Amber - Qty 2
- Vehicle Lights
- Tail Light
- Turn Signal
- Pair of Lights
- LED Light
- Replacement Bulb
- 7440
- Amber
- Putco
more information >
Continue Researching
- Article: Surviving the Night in a Teardrop Camper...During a Winter Storm
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Wiring Diagrams
- Article: Brake Controller Installation: Starting from Scratch
- Article: How to Measure for Trailer Hitch Drop
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: My Trailer Hitch Doesn't Fit